Beer Dispensers Service, Installation and Care Manual Please read this manual completely before attempting to install or operate this equipment. Notify carrier of damage! Inspect all components immediately.
Service and Installation Manual COMMECIAL REFRIGERATOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. Our product instructions will be uploaded on our company official website. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others.
Service and Installation Manual The key for appliance electric box should be safe kept by qualified persons in order to avoid a hazard WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. WARNING: Do not damage the refrigerant circuit.
Service and Installation Manual CONTENTS RECEIVING & INSPECTING EQUIPMENTIIIIIIIIIIIIIII..II.I.III4 SPECIFICATIONSIIIIIIIIIIIIIIIIIIII.IIIIIIIII...II...5 INSTALLATIONIIIIIIIIIIIIIIIIIIIIIIIIIIII.II..III.6 OPERATIONIII..IIIIIIIIIIIIIIIIIIIIIIIIII..III....I.7 MAINTENANCEIIIIIIIIIIIIIIIIIIIIIIIIIII.I.......I.I.....9 WIRING DIAGRAMIIIIIIIIIIIIIIIIIIIIIIIII...IIII...I12 All rights reserved. Reproduction without written permission is prohibited.
Service and Installation Manual SPECIFICATION BEER DISPENSERS MODEL# V/Hz/Ph AMPS MXBD24-1B MXBD48-1B MXBD48-2B MXBD60-1B MXBD60-2B MXBD72-2B 115/60/1 115/60/1 115/60/1 115/60/1 115/60/1 115/60/1 2.2 3 3 3 3 3 STORAG E CAPACIT Y 7.2 10.45 10.45 14.16 14.16 17.26 HP BTU 1/8 2/5 2/5 2/5 2/5 1/2 740 1155 1155 1155 1155 1771 SHIP CHARGE WEIGH NEMA OZ T PLUG LBS 2.82 161 5-15P 3.88 264 5-15P 3.88 267 5-15P 3.88 302 5-15P 3.88 304 5-15P 4.
Service and Installation Manual INSTALLATION Location Units represented in this manual are intended for indoor use only. Be sure the location chosen has a floor strong enough to support the total weight of the cabinet and contents. A fully loaded unit can weigh as much as 1500 pounds. Reinforce the floor as necessary to provide for maximum loading. For the most efficient refrigeration, be sure to provide good air circulation inside and out. Outside cabinet: Be sure that the unit has access to ample air.
Service and Installation Manual OPERATION Do not throw items into the storage area. Failure to heed these recommendations could result in damage to the interior of the cabinet. Refrigerators: The factory setting for temperature range is 34°F - 38°F On/Off Switch: An on/off switch is located on the side of the bottom shroud. When the unit is on, the switch will glow green. Light Switch: An light switch is located next to on/off switch on the front of the bottom shroud.
Service and Installation Manual 2. MAIN FUNCTIONS 2.1 HOW TO SEE THE SETPOINT 1. Push and immediately release the SET key: the display will show the set point value; 2. Push and immediately release the SET key or wait for 5 seconds to display the sensor value again. 2.2 HOW TO CHANGE THE SETPOINT 1. Push the SET key for more than 2 seconds to change the set point value; 2. The value of the set point will be displayed and the LED starts blinking; 3. To change the set value push the or key within 10s; 4.
Service and Installation Manual MAINTENANCE The power switch must be turned to OFF and the unit disconnected from the power source whenever performing service, maintenance functions or cleaning the refrigerated area. Refrigerators The interior and exterior can be cleaned using soap and warm water. If this isn't sufficient, try ammonia and water or a nonabrasive liquid cleaner. When cleaning the exterior, always rub with the "grain" of the stainless steel to avoid marring the finish.
Service and Installation Manual MAINTENANCE Cleaning solutions need to be alkaline based or non-chloride cleaners. Any cleaner containing chlorides will damage the protective film of the stainless steel. Chlorides are also commonly found in hard water, salts, and household and industrial cleaners. If cleaners containing chlorides are used be sure to rinse repeatedly and dry thoroughly upon completion. Routine cleaning of stainless steel can be done with soap and water.
Service and Installation Manual MAINTENANCE Swing Door Replacement and Adjustment 1. Open the bottom shroud and hold the door, then loose bottom hinge’s screws and take off the old door; 2. Prepare new door, insert top pin into top hinge, get one bottom hinge to hold the door by the bottom pin , then fasten bottom hinge securely to the door frame with three screws; 3. Allow the door to freely swing, make sure it swing close by itself with no restriction; 4.
Service and Installation Manual MAINTENANCE INSTALL DRAFT ARM AND PARTS LIST Place rubber washer over draft arm mounting holes in cabinet, put beer line connector down through hole. Next, secure draft arm with four screws. Insert air hose (one inch plastic tube) in draft arm, being careful not to disturb insulation. Remove top cover of draft arm and attach air hose clip to the insulating sleeve at the top of the draft arm. Replace top cover.
Service and Installation Manual STEP 1 - Remove black knockout plug with a pair of pliers. NOTE: Knockout plug for CO2 line can be locate in two different areas. View diagram to locate these two areas. STEP 2 - Use drill and bit to bore hole straight back through wall into compressor compartment. STEP 3 - Snake CO2 line through hole down and around exiting behind rear castor underneath rear grill. STEP 4 - Seal hole around CO2 line with silicone sealer to prevent cold air leakage.
Service and Installation Manual WIRING DIAGRAM Model: MXBD24-1B/MXBD24-1S Model: MXBD48-1B/MXBD48-1S/MXBD48-2B/MXBD48-2X/MXBD60-1B/ MXBD60-1S/MXBD60-2B/ MXBD60-2S 14
Service and Installation Manual WIRING DIAGRAM Model: MXBD72-2B/MXBD72-2S 15
Service and Installation Manual WIRING DIAGRAM Model: MXBD24-1B/MXBD24-1S 16
Service and Installation Manual WIRING DIAGRAM Model: MXBD48-1B/MXBD48-1S/MXBD48-2B/MXBD48-2X/MXBD60-1B/ MXBD60-1S/MXBD60-2B/ MXBD60-2S 17
Model: MXBD72-2B/MXBD72-2S WIRING DIAGRAM Service and Installation Manual
