Reach Ins Service, Installation and Care Manual Please read this manual completely before attempting to install or operate this equipment. Notify carrier of damage! Inspect all components immediately. IMPORTANT INFORMATION READ BEFORE USE PLEASE SAVE THESE INSTRUCTIONS! See page 2.
Service and Installation Manual CONTENTS RECEIVING & INSPECTING EQUIPMENT………………………………………..…………………2 SPECIFICATIONS…………………………………………………….……………………….………3 INSTALLATION………………………………………………………………………….…………..….4 OPERATION………..……………………………………………………………………..……………5 MAINTENANCE……………………………………………………………………….……………….7 WIRING DIAGRAM…………………………………………………………………………………9 All rights reserved. Reproduction without written permission is prohibited.
Service and Installation Manual SPECIFICATION CONTECH SOLID DOOR REFRIGERATORS STORAGE CAPACITY MODEL# V/Hz/Ph AMPS HP Cu-ft MXCR-23FDRE 115/60/1 3.8 23 3/8 SHELF CAPACITY Sq-ft 14.0 3200 CHARGE OZ 12.0 BTU SHIP WEIGHT NEMA LBS PLUG 350 5-15P MXCR-49FDRE 115/60/1 5.7 49 1/2 28.1 5800 18.7 518 5-15P MXCR-72FDRE 115/60/1 10 72 3/4 42.1 7625 21.2 669 5-15P MXCR-23GD 115/60/1 6.0 23 3/8 14.0 3200 12.0 518 5-15P MXCR-49GD 115/60/1 9.0 49 1/2 28.1 5800 18.
Service and Installation Manual INSTALLATION Location Units represented in this manual are intended for indoor use only. Be sure the location chosen has a floor strong enough to support the total weight of the cabinet and contents. A fully loaded unit can weigh as much as 1500 pounds. Reinforce the floor as necessary to provide for maximum loading. For the most efficient refrigeration, be sure to provide good air circulation inside and out.
Service and Installation Manual OPERATION Do not throw items into the storage area. Failure to heed these recommendations could result in damage to the interior of the cabinet. Refrigerated cycle Refrigerators: During the refrigeration cycle, the evaporator fans wilt run continuously even when one or more doors are open. The door switch will activate the lights when opened. 1. Every 6 hours, the unit will turn off and to allow the evaporator coil to defrost. The controller now displays defrost symbol.
Service and Installation Manual 1.1 Function of LEDS 2. MAIN FUNCTIONS 2.1 HOW TO SEE THE SETPOINT 1. Push and immediately release the SET key: the display will show the set point value. 2. Push and immediately release the SET key or wait for 5 seconds to display the sensor value again. 2.2 HOW TO CHANGE THE SETPOINT 1. Hold the SET key for more than 2 seconds to change the set point value. 2. The value of the set point will be displayed and the LED starts blinking. 3.
Service and Installation Manual MAINTENANCE The unit must be turned OFF and disconnected from the power source whenever performing service, maintenance functions or cleaning the refrigerated area. Refrigerators and Freezers The interior and exterior can be cleaned using soap and warm water. If this isn't sufficient, try ammonia and water or a nonabrasive liquid cleaner. When cleaning the exterior, always rub with the "grain" of the stainless steel to avoid marring the finish.
Service and Installation Manual MAINTENANCE Cleaning solutions need to be alkaline based or non-chloride based. Any cleaner containing chlorides will damage the protective film of the stainless steel. Chlorides are commonly found in hard water, salts, and household and industrial cleaners. If cleaners containing chlorides are used, be sure to rinse and dry thoroughly. Routine cleaning of stainless steel can be done with soap and water.
Service and Installation Manual WIRING DIAGRAM MODEL：MXCR-23FDRE MODEL：MXCR-49FDRE 9
Service and Installation Manual WIRING DIAGRAM MODEL：MXCR-72FDRE MODEL：MXCR-23GD 10
Service and Installation Manual WIRING DIAGRAM MODEL：MXCR-49GD MODEL：MXCF-23FDRE 11
Service and Installation Manual WIRING DIAGRAM MODEL：MXCF- 49FDRE MODEL：MXCF-72FDRE 12
Service and Installation Manual WIRING DIAGRAM MODEL: MXCR-23FDRE 13
Service and Installation Manual WIRING DIAGRAM MODEL: MXCR-23GD 14
Service and Installation Manual WIRING DIAGRAM MODEL: MXCF-23FDRE 15
Service and Installation Manual WIRING DIAGRAM MODEL: MXCR-49FDRE 16
Service and Installation Manual WIRING DIAGRAM MODEL: MXCR-49GD 17
Service and Installation Manual WIRING DIAGRAM MODEL: MXCF-49FDRE 18
Service and Installation Manual WIRING DIAGRAM MODEL: MXCR-72FDRE 19
Service and Installation Manual WIRING DIAGRAM MODEL: MXCF-72FDRE 20
Service and Installation Manual 21
