Service and Installation Manual CONTENTS RECEIVING & INSPECTING EQUIPMENT………………………………………..……………………….2 SPECIFICATIONS…………………………………………………….……………………….…………….3 INSTALLATION………………………………………………………………………….…………………..4 OPERATION………..……………………………………………………………………..………………..5-6 MAINTENANCE……………………………………………………………………….…………………..7-9 All rights reserved. Reproduction without written permission is prohibited.
Service and Installation Manual SPECIFICATION SWING GLASS DOOR REFRIGERATORS STORAGE CAPACITY MODEL# V/Hz/Ph AMPS Cu-ft MXM1-12R 115/60/1 6 12 MXM1-16R 115/60/1 6 16 MXM1-23R 115/60/1 6 23 MXM2-48R 115/60/1 7 48 MXM3-72R 115/60/1 10 72 HP 3/8 3/8 3/8 1/2 3/4 CHARGE OZ 12.0 12.0 12.0 18.7 21.
Service and Installation Manual INSTALLATION Location Units represented in this manual are intended for indoor use only. Be sure the location chosen has a floor strong enough to support the total weight of the cabinet and contents. A fully loaded unit can weigh as much as 1500 pounds. Reinforce the floor as necessary to provide for maximum loading. For the most efficient refrigeration, be sure to provide good air circulation inside and out.
Service and Installation Manual OPERATION Do not throw items into the storage area. Failure to heed these recommendations could result in damage to the interior of the cabinet. Refrigeration cycle Refrigerators: Every 6 hours, the unit will shut off to allow the evaporator coil to defrost and the controller will display the defrost symbol. When the coil temperature reaches 41°F or after 20 minutes, the unit returns to the refrigeration cycle. The factory setting for temperature range is 28° to 34°F.
Service and Installation Manual 1.2 Function of LEDS 2. MAIN FUNCTIONS 2.1 HOW TO SEE THE SETPOINT 1. Push and immediately release the SET key: the display will show the set point value; 2. Push and immediately release the SET key or wait for 5 seconds to display the sensor value again. 2.2 HOW TO CHANGE THE SETPOINT 1. Push the SET key for more than 2 seconds to change the set point value; 2. The value of the set point will be displayed and the LED starts blinking; 3.
Service and Installation Manual MAINTENANCE The power switch must be turned to OFF and the unit disconnected from the power source whenever performing service, maintenance functions or cleaning the refrigerated area. Refrigerators and Freezers The interior and exterior can be cleaned using soap and warm water. If this isn't sufficient, try ammonia and water or a nonabrasive liquid cleaner. When cleaning the exterior, always rub with the "grain" of the stainless steel to avoid marring the finish.
Service and Installation Manual MAINTENANCE Cleaning solutions need to be alkaline based or non-chloride cleaners. Any cleaner containing chlorides will damage the protective film of the stainless steel. Chlorides are also commonly found in hard water, salts, and household and industrial cleaners. If cleaners containing chlorides are used be sure to rinse repeatedly and dry thoroughly upon completion. Routine cleaning of stainless steel can be done with soap and water.
Service and Installation Manual MAINTENANCE Swing Door Replacement and Adjustment 1. Open the bottom shroud and hold the door, then loosen the bottom hinge’s screws and take off the old door. 2. Prepare new door, insert top pin into top hinge, get one bottom hinge to hold the door by the bottom pin, then fasten bottom hinge securely to the door frame with three screws; 3. Allow the door to freely swing, make sure it swings closed by itself with no restriction. 4.
Service and Installation Manual MXMMAN 0512 Ver A 10