COUNTER TOP DISPLAY CASE FREEZER REFRIGERATED COUNTER TOP DISPLAY CASE Service, Installation and Care Manual Please read this manual completely before attempting to install or operate this equipment. Notify carrier of damage! Inspect all components immediately. IMPORTANT INFORMATION READ BEFORE USE PLEASE SAVE THESE INSTRUCTIONS! See page 2.
Service and Installation Manual CONTENTS RECEIVING & INSPECTING EQUIPMENT………………………………………..…………………2 SPECIFICATIONS…………………………………………………….……………………….………3 INSTALLATION………………………………………………………………………….…………..….4 OPERATION………..……………………………………………………………………..……………5 MAINTENANCE……………………………………………………………………….……………….6 WIRING DIAGRAM…………………………………………………………………………………9 All rights reserved. Reproduction without written permission is prohibited.
Service and Installation Manual SPECIFICATION REFRIGERATED COUNTER TOP DISPLAY CASE STORAGE CAPACITY MODEL# V/Hz/Ph AMPS HP Cu-ft MXM1-2R 115/60/1 1.5A 2.4 1/6 MXM1-2.5R 115/60/1 1.5A 3.1 1/6 MXM1-3.5R 115/60/1 1.5A 4.1 1/4 MXM1-4R 115/60/1 1.5A 4.8 1/4 COUNTER TOP DISPLAY CASE FREEZER STORAGE CAPACITY MODEL# V/Hz/Ph AMPS Cu-ft 1.7 MXM1-2F 115/60/1 2.0A 2.5 MXM1-2.5F 115/60/1 2.0A 3.1 MXM1-3.5F 115/60/1 2.0A 4.1 MXM1-4F 115/60/1 2.
Service and Installation Manual INSTALLATION Location Units represented in this manual are intended for indoor use only. Be sure the location chosen has a floor strong enough to support the total weight of the cabinet and contents. A fully loaded unit can weigh as much as 1500 pounds. Reinforce the floor as necessary to provide for maximum loading. For the most efficient refrigeration, be sure to provide good air circulation inside and out.
Service and Installation Manual OPERATION Do not throw items into the storage area. Failure to heed these recommendations could result in damage to the interior of the cabinet. Refrigeration cycle Refrigerators: The factory setting of the temperature range is 17 to 14F. Freezers: 1. Anti-Condensation heaters on the door frames work in conjunction with the compressor. 2. The factory setting of the temperature range is 0 to -10F On/Off Switch: An on/off switch is located on the front of the bottom panel.
Service and Installation Manual MAINTENANCE The power must be turned OFF and the unit disconnected from the power source whenever performing service, maintenance functions or cleaning the refrigerated area. Refrigerators and Freezers The interior and exterior can be cleaned using soap and warm water. If this isn't sufficient, try ammonia and water or a nonabrasive liquid cleaner. When cleaning the exterior, always rub with the "grain" of the stainless steel to avoid marring the finish.
Service and Installation Manual MAINTENANCE Cleaning solutions need to be alkaline based or non-chloride based. Any cleaner containing chlorides will damage the protective film of the stainless steel. Chlorides are commonly found in hard water, salts, and household and industrial cleaners. If cleaners containing chlorides are used, be sure to rinse repeatedly and dry thoroughly. Routine cleaning of stainless steel can be done with soap and water.
Service and Installation Manual MAINTENANCE Swing Door Replacement and Adjustment 1. Open the bottom panel and hold the door. Then loosen the bottom hinge screw and take off the old door. 2. Prepare new door; insert top pin into top hinge, get one bottom hinge to hold the door with the bottom pin. Fasten bottom hinge securely to the door frame with three screws. 3. Allow the door to freely swing, making sure it swings closed by itself with no restriction. 4.
Service and Installation Manual WIRING DIAGRAM MODEL: MXM1-2R/MXM1-3.5R MODEL: MXM1-2.
Service and Installation Manual WIRING DIAGRAM MODEL: MXM1-2F/MXM1-3.5F MODEL: MXM1-2.
Service and Installation Manual WIRING DIAGRAM MODEL: MXM1-2R/MXM1-3.
Service and Installation Manual WIRING DIAGRAM MODEL: MXM1-2.
Service and Installation Manual WIRING DIAGRAM MODEL: MXM1-2F/MXM1-3.
Service and Installation Manual WIRING DIAGRAM MODEL: MXM1-2.
Service and Installation Manual 15
Service and Installation Manual 16