MILK COOLERS Service, Installation and Care Manual MXMC34HC MXMC58HC IMPORTANT INFORMATION PLEASE READ CARFEULLY MXMC49HC
Service and Installation Manual CONTENTS SERIAL NUMBER INFORMATION……...………………..……………………………………………………….3 RECEIVING AND INSPECTING THE EQUIPMENT……………………………………….…………………..3 COMMERICAL REFRIGERATION SAFETY & WARNINGS …………..…………….…………………….…4 SPECIFICATIONS…………………………………………………….……………………….………6 CONGRATULATIONS ON YOUR NEW COOLER…………………………………….………6 INSTALLATION………………………………………………………………………….…………..6-7 ELECTRICAL CONNECTION……………………………………………………………………….....….7 FOOD STORAGE.………………………………………………….
Service and Installation Manual SERIAL NUMBER INFORMATION The serial number of the milk cooler is located inside the unit on the left-hand side near the top on the wall. Always have the serial number of your unit available when calling for parts or service. Also, retain proof of purchase including the order date or your warranty will be voided. This manual covers standard units only. If you have a custom unit, consult the customer service department at the number listed in the back cover.
Service and Installation Manual COMMERCIAL REFRIGERATION SAFETY Your safety and the safety of others are very important. We will provide important safety messages in this manual and on your appliance. Always read and obey all safety messages. Our product instructions will be uploaded on our company website. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injury you and others.
Service and Installation Manual WARNING The appliance uses flammable insulation blowing gas C5H10, disposal of the appliance must be in accordance with the regulations of local authorities regarding flammable items. CAUTION – Risk of Fire or Explosion due to Flammable Refrigerant Used. Follow Handling Instructions Carefully in Compliance with U.S. Government Regulations.
Service and Installation Manual SPECIFICATIONS MODEL# V/Hz/Ph STORAGE CAPACITY Cu-ft CAPACITY (13”x13”x11” Crates) 13.2 19.6 23.5 8 12 16 MXMC34HC 115/60/1 MXMC49HC 115/60/1 MXMC58HC 115/60/1 CAPACITY AMP (19”x13”x11” DRAW Crates) 4 8 10 4 7.5 7.5 HP CHARGE OZ REFRIGERANT NEMA PLUG 1/4 1/4 1/3 3.17 3.17 3.17 R290A R290A R290A 5-15P 5-15P 5-15P CONGRATULATIONS ON YOUR NEW COOLER Note these instructions apply to all milk coolers.
Service and Installation Manual ELECTRICAL CONNECTION The cooler must be connected to a NEMA 5-15 or 5-20 receptacle with the correct voltage/frequency, as show on the nameplate. The standard for U.S is 115V/60Hz. Voltage variations of ±10% are acceptable. Greater variations can damage the cooler, and in such cases the factory warranty is not valid. In the case of extreme voltage variation, above or below the standard, your local supplier or utility company will be able to advise you, what to do.
Service and Installation Manual SOLID STATE THERMOSTAT DESCRIPTIONS 1. FRONT PANEL COMMANDS To display target set point; in programming mode it selects a parameter or confirms an operation.
Service and Installation Manual Hold the and keys together for more than 3s, till the “POF” message is displayed. 3. ALARM SIGNALS HOW TO SEE THE ALARM AND RESET THE RECORDED ALARM 1. Hold the or key to display the alarm signals. 2. When the signal is displayed, hold the SET key until the “rst” message is displayed, and push the SET key again.
Service and Installation Manual needed Never use a high-pressure water wash for this cleaning procedure as water can damage the electrical components located near or at the condenser coil. DANGER MAINTENANCE 1.3 CLEAN THE GASKET - The door gasket should be cleaned frequently to maintain proper sealing 1.4 CHECK AFTER CLEANING - Check the unit again for safety - Check that the unit is operating properly 2. The lid may be cleaned in the same way as the cooler. 3.
Service and Installation Manual TROUBLE SHOOTING SYMPTOMS CAUSES SOLUTIONS The unit is freezing The temperature is set too low to Turn the temperature dial to a maintain safe, read to serve product. warmer setting – allow 2 hours for unit to reach steady state condition and confirm product temperature is within the 34° to 40°F ideal holding range. The unit does not refrigerate at all There is a power connection Check the power cord to make sure the failure problem.
Service and Installation Manual DISPOSAL When a worn-out cooler is to be disposed of, this must be done properly. Please be aware of any regulations covering the disposal of such items; there may be special local or state requirements or conditions to be followed. Information about disposal may be obtained from: —The firm you purchased the cooler from; —The relevant authorities (the Local Authority, environmental agencies, etc.). —Your local disposal ,dumpster or local trash company.
Service and Installation Manual EXPLODED VIEW AND PARTS LISTING MODEL： MXMC34HC / MXMC49HC / MXMC58HC Number Description Number Description 1 TOP LID 18 CONDENSER 2 TOP SEAL 19 UNIT BOARD 3 LOCK 20 BRAKE WHEEL 4 DOOR HINGE 21 NORMAL WHEEL 5 DOOR SEAL 22 THERMOSTAT 6 LOCATION KNOB 23 THERMOSTAT BOX 7 HOOK PLATE 24 THERMOSTAT BOX COVER 8 LOCK HOOK 25 SEAL 9 FRONT DOOR 26 SENSOR FIXED CLIP 10 SUCTION PIPE + CAPILLARY 27 PROBE PADDING 11 COMPRESSOR 28 LOCATION AX
Service and Installation Manual WIRING DIAGRAM MODEL： MXMC34HC / MXMC49HC / MXMC58HC 14
Service and Installation Manual NOTES: 11 15
Service and Installation Manual 3355 Enterprise Ave., Suite 160 - Ft. Lauderdale, FL 33331 T: (954) 832-3724 - F: (954) 202-7337 www.maxximumfoodservice.
