MCR3U Indoor Refrigerator English PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE INSTRUCTION MANUAL Be sure unit is standing upright 24 hours prior to plug-in.
IMPORTANT SAFEGUARDS Read all instructions before using this appliance. Use this appliance only for its intended purpose as described in this instruction manual. Always exercise basic safety precautions, as described below. After reading the instruction manual, store it in an accessible place where the user(s) of this product can easily find it.
IMPORTANT SAFEGUARDS 1. All repairs, disassembly and modifications should be performed only by qualified technicians. Attempting to perform these yourself could result in fire, malfunction or injury. 2. Never splash water directly onto the product or wash it with water without unplugging, as a short circuit could result. In a rainy environment, a water-proof covering is recommended. 3. Never put flammable or volatile substances into the unit as explosion and fire could result. 4.
1. This unit must be properly installed in accordance with the installation instructions before it is used. See grounding instructions in the Installation section. 2. This model can either be built-in or free-standing. Built-in units vent at the bottom front and airflow at the front of this vent must be unimpeded. 3. Install the unit in a location where the floor is sturdy enough to support the load of the unit.
TECHNICAL SPECIFICATIONS Model Number: Description: Electrical Input: Current Rating: Unit Dimensions: MCR3U Indoor Refrigerator 115VAC ~ 60Hz 2.0A 14⅝”W x 24⅜”D x 33½”H 371.475 mm W x 619.125 mm D x 850.9 mm H Unit Weight: Ambient Temperature Range: Compartment Temperature Range: 69 lbs/31.29kg 25ºF - 100ºF /3.8ºC -37.77ºC 35ºF - 50ºF / 1.66ºC - 10ºC Energy-Saving Tips • • • Do not place the unit next to a heating vent, a range or in direct sunlight.
INSTALLATION Remove the exterior and interior packaging. Use a soft dry cloth to wipe down the outside of the refrigerator thoroughly. Use a clean cloth dampened with lukewarm water to wipe down the inside of the refrigerator. Air must circulate freely in front of the refrigerator. Avoid placing the appliance near any source of heat or moisture, or in direct sunlight. Direct sunlight may affect the finish, and nearby heat sources will cause higher electrical consumption.
INSTALLATION door. Set aside. 5. Using a Phillips screwdriver, remove the magnet baffle and door switch baffle, then place them on the opposite side at the top of the door. 6. Push the four plug buttons into the spare screw holes. To replace door on hinges: 1. Using a flat screwdriver, remove the plug buttons from the screw holes opposite the door hinges, top and bottom. Set aside. 2. Remove the bottom hinge and place it on the opposite side at the bottom of the door. 3.
OPERATING YOUR REFRIGERATOR IMPORTANT: Do not plug in the refrigerator for 24 hours after unit is set in place. Failure to do so may result in the unit working improperly. This refrigerator has a rotary temperature control knob (thermostat) inside the unit which is marked with the settings OFF-COLD-COLDEST in order of increasing coldness. Note: To prevent excessive strain on the compressor, do not leave the unit at the COLDEST setting for more than an hour at a time.
OPERATING YOUR REFRIGERATOR variation from the bottom of the unit to the top. The temperature at the bottom of the unit will always be slightly colder. Operating the Internal Light This appliance has an internal light to make it easier for you to see the foods you have stored. When the door is open, the light will be on and when it is closed, the light will be off. Shelving The wire racks in your unit are chrome-plated so they will not rust.
CLEANING & MAINTENANCE Cleaning the Outside Unplug your refrigerator. Clean the outside with a cloth dampened in warm soapy water. Dry thoroughly with a soft cloth. To clean the door gasket, use only warm soapy water. Never use harsh cleansers or scouring pads to clean any part of your unit. Cleaning the Inside Remove all foods, plus shelves and basket. Wash the shelves and basket in a mild detergent solution and dry with a soft cloth.
TROUBLESHOOTING Unit does not turn on Not plugged in. Fuse blown or circuit breaker tripped. Noise or vibration Check that unit is level. If not, adjust leveling legs. Unit is too warm Check that door is properly closed and sealed. Check temperature setting. (To change the temperature setting, follow the steps in the Operating Your Refrigerator section of this manual.) Check if door has been opened frequently.
WIRING DIAGRAM 11
NOTES: 12
NOTES: 13
NOTES: 14
www.maxxcold.
