Use and Care Manual

6
Memorized Temperature Setting
The unit has been designed to “remember” the last run mode to which it was set. If
there is a power outage or any other power cutoff, the unit will automatically return
to the previous temperature setting after power is returned.
Compressor Run Indicator
The compressor is running when the unit displays a moving icon representing a run-
ning fan. If the compressor stops running, the icon will stop moving as well.
About the Liquid Crystal Display (LCD)
When you press any button on the control panel, a backlight will appear in the dis-
play. If no other button is pressed, the backlight will automatically go out after 2 min-
utes.
ALARM Mode
In the event that there is a fault in the unit, an ALARM indication will appear on the
screen.
In ALARM mode, the unit will make a beeping sound and display an alarm message.
If the LCD on the control panel displays any of the following messages: PROBE
ERROR, LOW TEMP or HIGH TEMP, consult the Wine Cellar Troubleshooting section of
this manual.
Interior Light
The interior light can be operated manually by pressing the ON/OFF button on the
control panel. The light will automatically turn off after 5 minutes.
NOTE: Avoid overuse of the interior light since the heat generated can raise the tem-
perature of the stored wine.
Shelving
The wine racks in your unit are chrome-plated so they will not rust. These racks pull out
only 1/3 of the way. This is a safety feature so that neither the machine nor the rack
will tip over.
The five upper racks are designed to hold five bottles each, with alternating bottles
on each rack pointing in opposite directions. These racks are removable and re-
versible. To remove a rack, take out the bottles on the rack and pull it out until it
stops. Then lift up the front of the rack and remove it from the unit.
The lowermost shelf is tilted and can hold three bottles. It is designed for storage as
well as for display.
OPERATING YOUR WINE CELLAR