Use and Care Manual

19
the power switch again and the machine will automatically go into the ice-making process.
6.
If you want to interrupt the cleaning mode before it is finished, do not press the Clean
button again. Instead, turn the power switch off. This stops the cleaning cycle.
7.
If the machine is on but only the power indicator light is lit, this may indicate that not
enough water is reaching the system, that the water pump is not functionin
g, or some
similar problem. First check the level in the water tank, then examine the water pump, etc.
8.
If the unit is connected to the power supply but no visual indicator lights up when the
power switch is turned on, the fuse in the control panel box may need to be replaced.
1. Bin Full (white) LED: Bin Full indicator light When this LED is on, it indicates that the
ice level in the bin is high enough to hold the water curtain open, the microswitch is open,
or there is something obstructing the closing of the water curtain. The unit will stop
working. When ice cubes are rem
oved from the ice storage bin, clearing the ice-full probe,
the white LED will flash for 3 minutes. Then the unit will restart and return to the
ice-making mode.
2. Ice Making (Green) LED: Ice Making indicator light When this LED is on, the unit is in
the ice-making mode.
3. Ice Harvest (Yellow) LED: Ice Harvest indicator light When this LED is on, the unit is
working in the ice harvest mode.
4. Power (White) LED: Power indicator light When the main power switch that is located on
the left side of the unit is turned on, The power indicator LED is on ,the unit starts working
after 3 minutes.
5. Mode button: This button is mainly for service. When it is pressed, the ice making mode
changes to ice harvest mode or vice versa. The mode is indicated by the status of the green
or yellow LEDs.
6. Clean button If you press the Clean button within three minutes after the power has been
turned on, the ice maker will enter the cleaning mode. If press the Clean button and hold it
for more than six seconds, the machine will enter the draining mode. The green and yellow
LEDs will be blinking together.
Ice Size Adjustment Guide:
1. Press and hold the “Clean” button and the “Mode” button together for at least 3 seconds.
The unit will enter the Ice Size Adjustment mode. The “ICE” LED (green) will be blinking
continuously during the ice size adjustment.
2. While in the Ice Size Adjustment mode, press the “Clean” button or the “Mode” button for
the desired ice size.
Smaller ice setting:
By pressing the “Clean” button, you can decrease the size of the ice cubes. The “FULL”
LED (red) will flash as you lower the ice size and will finally be blinking at the setting of
smallest ice size.
Larger ice setting:
By pressing the “Mode” button, you can increase the size of the ice cubes. The
“HARVEST” LED (yellow) will flash as the larger size is set and will blink when the
setting of largest ice size has been reached.
After 10 seconds without any operation, the unit will automatically memorize the current
state and return to the previous mode.
NOTE: If during the ice size adjustment, the “BIN FULL”, “ICE” and “HARVEST”
LEDS blink all at once, this indicates that the unit is in the default factory setting of the ice
size adjustment.
IMPORTANT: .Avoid letting water contact the control box
１９