User Manual

25
© 2019 The Legacy Companies
Crescent Ice Maker Instruction Manual
TROUBLESHOOTING
8
PROBLEM POSSIBLE CAUSES SOLUTIONS
• The machine won't operate. • The ice maker is unplugged.
• The ice maker power switch is
OFF.
• The ice storage bin is full of ice.
• Plug the ice maker in.
• Turn the ice maker power switch
to ICE (ON).
• Take away some ice cubes; make
sure the “ice full” probe is free of
ice.
• The compressor works
abnormally with a buzzing noise.
• The voltage is lower than
recommended.
• Stop the ice maker and do not
restart until the voltage is normal.
• The water doesn't feed in after
the ice maker starts.
• The water supply tap is turned
off.
• The water supply pipe is not
properly connected.
• Turn on the water supply tap.
• Reconnect the water supply pipe.
• Machine makes ice, but bin does
not ll up with ice.
• The condenser may be dirty.
• The airow to the ice maker may
be obstructed.
• The ambient temperature and
water temperature are high, or it
is near with some heat source.
• Clean the condenser.
• Check the installation.
• Run the unit for a longer period
of time.
• Water is leaking out of the unit. • A few water droplets are on the
door.
• The water supply connection is
leaking.
• Under some conditions, humidity
may condense on the door.
Consider moving the unit or just
be more careful when you open
the door.
• Tighten water supply hose tting.
• Cubes are partially formed and
are white at the bottom.
• There is not enough water in the
water bin.
• Check if the water supply
pressure is below 15 psi.
• Check the water supply. It may be
restricted.
• Check for a water leak at the
water trough.
• Noise during operation. • The feet are not leveled and
locked.
• Certain sounds are normal.
• Level the feet. See “Leveling the
Ice Maker” on page 15.
• See “Normal Sounds” on page 19.