Instructions / Assembly

16 & 18 INCH PLASTIC PEDESTAL FAN
Models HVPF 16P and HVPF 18P
O
O
P
P
E
E
R
R
A
A
T
T
I
I
N
N
G
G
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
READ AND SAVE THESE INSTRUCTIONS
CAUTION
Read Rules for Safe Operation and Instructions Carefully.
WARNING
If the supply cord is damaged, it must be replaced by manufacturer or
its service agent or a similarly qualified person in order to avoid a
hazard.
This appliance has a polarized plug (one blade is
wider than the other). To reduce the risk of electric
shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat this safety feature.
RULES FOR SAFE OPERATION
1. Never insert fingers, pencils, or any other object through the
grille when fan is running.
2. Disconnect fan when moving from one location to another.
3. Disconnect fan when removing grilles for cleaning.
4. Be sure fan is on a stable surface when operating to avoid
overturning.
5. DO NOT use fan in window, rain may create electrical hazard.
6. This product employs overload protection (fuse). A blown fuse
indicates an overload or short-circuit situation. If the fuse blows,
unplug the product from the outlet. Replace the fuse as per the
user servicing instructions (follow product marking for proper
fuse rating) and check the product. If the replacement fuse blows,
a short -circuit may be present and the product should be
discarded or returned to an authorized service facility for
examination and/or repair.
7. Do not operate any fan with a damaged cord or plug. Discard fan
or return to an authorized service facility for examination and/or
repair.
8. Do not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from traffic area and
where it will not be tripped over.
9. WARNING - To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-State Speed Control Device.
AVERTISSEMENT: NE CONVIENT PAS A DES REGULATEURS DE VITESSE A SEMI-CONDUCTEURS.
COLUMN ASSEMBLY
1. Attach column to stand with screw as shown.
2. Unscrew / take out height adjustment ring.
3. Slide stand ornament down the column to rest on stand.
4. Pull out the extension pipe and screw / fasten the height adjustment ring back.
CAUTION: Height adjustment ring must be fully fastened before the assembly of the motor section to the stand.
ASSEMBLY INSTRUCTIONS
1. Unscrew the spinner clockwise and the nut counter- clockwise to remove both of them.
2. Set the rear guard in the proper position with handle up.
3. Screw on plastic nut tightly to attach rear guard.
4. Install the fan blade onto the motor shaft until it reaches the retaining pin.
5. Screw spinner onto motor shaft counter clockwise to blade.
6. Unscrew the locking screw mounted on the rear grille. Mount front grille onto rear grille with the small round holes on the top matched for
the passage of locking screw. Fix both grilles with clips and then use screw driver to tighten the locking screw.