20 IN.® OUTDOOR PEDESTAL FAN MODEL #: HVPF-20 OR English Utilitech & UT Design is a registered trademark of LF, LLC. All rights reserved.
PACKAGE CONTENTS A B C PART DESCRIPTION QUANTITY B C Stand Pole Base 1 1 A Fan Body 2 1
HARDWARE CONTENTS (shown actual size) AA Plastic Nut Tightener Qty. 2 (preassembled) ! BB Screw Qty. 2 CC Spring Washer Qty. 2 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. If you have any questions regarding the product, please call customer service at 1-800-433-1626 WARNING PLEASE READ AND SAVE THESE INSTRUCTIONS.
WARNING • THE POWER CORD is equipped with a three-prong, grounded GFCI (Ground Fault Circuit Interrupter) plug that must be inserted into a grounded receptacle or GFCI power outlet. Under no circumstances must the grounding prong be cut off the plug. CAUTION • CONSIDER YOUR WORK AREA ENVIRONMENT.
ASSEMBLY INSTRUCTIONS 1. Attach stand pole (B) to the base (C) and secure with 4 screws (BB) and 4 spring washers (CC) Make sure all screws are tightened firmly.
ASSEMBLY INSTRUCTIONS 2 2. Attach the fan body (A) to the stand pole (B). Align holes on the pole of fan body (A) and attach 2 screws (BB) and 2 spring washers (CC), then tighten the screws (BB) firmly. AA To adjust air flow up and down, tilt the fan to the desired angle. Tighten the plastic nut tightener (AA) on both tilt nuts to secure fan head. CC BB HARDWARE USED AA Plastic Nut Tightener x2 BB Screw x2 Spring Washer x2 CC OPERATING INSTRUCTIONS 1.
OPERATING INSTRUCTIONS 2 2. ADJUSTING AIR SPEED The fan has three speeds (LOW, MEDIUM and HIGH). Pull the chain of the speed control switch on the back of the unit to adjust air flow to desired speed. CARE AND MAINTENANCE • • • • Unplug from electrical source to clean. Use soft, damp cloth to clean. Following that, wipe with clean, dry cloth. Do not bend the fan blades. Store in a dry place.
VENTAMATIC, LTD. LIMITED WARRANTY Ventamatic, Ltd. extends this warranty to the original retail purchaser of its model or, if this unit is purchased and installed by a building contractor, then to the original owner of the home. No subsequent purchaser of the unit or of a home which it is installed is entitled to any of the benefits of this warranty. This product is warranted against defects in materials and workmanship for a period of one (1) year from the date of original retail purchase.
REPLACEMENT PARTS LIST PART A B C D E F G H K AA DESCRIPTION Fan Motor Stand Pole Base Fan Blade Speed Switch Power Cord U Arm Drum Rear Grille Front Grille Cover Ring Plastic Tightener PART # 20P-OD-01 20P-OD-02 20P-OD-03 20P-OD-04 20P-OD-05 20P-OD-06 20P-OD-07 20P-OD-08 20P-OD-09 20P-OD-10 20P-OD-11 20P-OD-12 H I A E AA J D F G K C B TECHNICAL DATA VOLTAGE/FREQUENCY 120 V/60 Hz CURRENT 1.