User Manual

Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied.

The cord should be secured behind the refrigerator and not le exposed or dangling to prevent accidental

injury.

Never unplug the refrigerator by pulling the power cord. Always grip the plug rmly and pull it straight out

from the receptacle.

Do not use an extension cord with this appliance. If the power cord is too short, have a qualied electrician or

service technician install an outlet near the appliance.

 Reversing the Door Swing of Your Appliance

This unit has the capability of opening the door either from the le or the right side. The unit is delivered to you with the door

opening from the le side. Should you desire to reverse the opening direcon, please follow the instrucons.

Note: Before reversing the door, the power must be shut o. All parts removed must be saved for reinstalling the door.

This unit has been built with the door hinges on the right. If you wish to change the opening direcon, follow the instrucons below:

1. Remove the upper hinge cover (6) rst.

2. Remove the three screws (1) that hold the upper hinge (5) (right side) to the frame and take away the upper hinge (5) (right side).

3. Li the door and place it on a padded surface to prevent scratching it.

4. Remove the three screws (8) that hold the lower hinge (2) and make sure to remove the lower hinge (2).

5. Remove the le front leg (4) and transfer it to the right side.

6. Remove the whole cover plate (7) at the right side.

7. Before placing the lower hinge (2), remove the bolt pin (9) and reverse the direcon of the lower hinge (2). Then install the lower

hinge (2) onto the le side of the lower frame with the three screws.

8. Insert the bolt pin into the lower hinge (2).

9. Set the door to its place in the lower hinge (2).

10. While holding the door in the closed posion, secure the upper hinge (5) to the top frame of the le side with the three screws.

Please remember not to ghten the three screws unl the top of the door is leveled with the counter top.

11. Install the upper hinge cover (6) on the upper hinge.