Installation Guide

Ceiling Light Installation Guide
3 YEAR WARRANTY
• Risk of electric shock - Disconnect power at the source
before installation.
• If you are unsure about the installation or the maintenance
of the wall light, please consult an electrician.
• Do not make or alter any holes in the wiring enclosure or
modify any electrical componentry.
CAUTIONS
• To insure personal safety, proper grounding of the
electrical fixture is required.
•
•
•
The fixture must be wired in accordance with the National
Electric Code and applicable local codes or ordinance
Min 90℃ Supply Conductors Les Fils D'alimentation 90℃
Min
Turn off the main power at the circuit breaker before
installing the fixture, in order to prevent possible shock.
s.
WARNINGS
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship
only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship
and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima
product. This offer does not constitute in any way a product guarantee and Maxxima does not here
by assume any obligation whatsoever beyond
sending a free replacement product.
INSTALLATION INSTRUCTIONS
CCT Color Selection
Tools Needed: Screwdriver, drill, wire nuts, electrical tape.
If you are replacing an existing fixture, remove and disconnect
the old fixture first.
1. Place the canopy against the ceiling in the desired orientation
and mark the locations of the mounting keyhole slots.
2. If necessary, drill holes for drywall anchors in the marked
locations and install the anchors.
3. Install the supplied mounting screws. Leave approximately 1/4
inch of screw length exposed in order to mount the canopy.
4. Expose the power supply wires from the junction box.
5. Connect the green fixture ground wire to the junction box
ground wire by using a wire nut.
6. Connect the white fixture neutral wire to the junction box white
neutral wire by using a wire nut.
7. Connect the black fixture hot wire to the junction box black hot
wire by using a wire nut.
8. Align the canopy base over the mounting screws so that the
screw
heads come through the keyhole slots.
9. Shift the canopy base slightly until the screws are at the small
end of the keyhole slots.
10. Tighten the mounting screws until the canopy base is snugly
seated against the ceiling. Be sure that the wires are placed
properly within the junction box.
11. Place the diffuser on the canopy. Then place the metal ring on
the diffuser. Let the 4 screws from the ring mount tubes protrude
through the holes in the metal ring.
12. Twist the 4 decorative nuts onto the ring mount tubes to secure the ring and diffuser.
13. The installation is complete. Restore power to the fixture and verify the fixture operates properly.
M4 DECORATIVE NUTS
CANOPY
WHITE (NEUTRAL)
WIRE
BLACK (HOT) WIRE
GROUND WIRE
DIFFUSER
RING MOUNT
TUBE
METAL
RINGS
DRYWALL ANCHORS
(OPTIONAL)
MOUNTING
SCREWS
RIS9864
1. Adjust CCT switches on each board accordingly to the desired color temperature as seen below. All boards
must be set the same way.
Note:Fixture is preset to 3000K from factory.Power to fixture must always be turned OFF prior to adjusting
CCT switches.
Color Changing Temperature Adjustment, CCT (if desired).
3000K 4000K 5000K 3000K 4000K 5000K
3000K 4000K 5000K
COLOR TEMPERATURE ADJUSTMENT SETTING
MCL-3324900SN
www.maxximastyle.com
88711 YN ,eguappuaH truoC tobaC 521moc.elytsamixxam.www)2649-926( AMIXXAM-668 moc.elytsamixxam@ofni