Instructions / Assembly

3.
4.
5.
6.
7.
CAUTIONS
NOTES
1.
2.
1.
2.
3.
www.maxximastyle.com
Three Year Warranty:
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in
material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/
purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty
period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This
offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation
whatsoever beyond sending a free replacement product.
Hole Diameter: 8.25" (208mm)
SPRING-LOADED CLIPS
CONNECTOR
DRIVER/JUNCTION BOX
LIGHT PANEL
Hole Cutout Diameter
The Hole Cutout Diameter size is 8.25
" or
208mm
8" Round Slim LED Flat Panel Installation Instructions
The units covered in these instructions are intended to retrofit Type IC or Type Non-IC luminaries.
Risk of fire. Supply conductors (power wires) connecting to the fixture must be rated 90° C. If
uncertain, consult an electrician.
Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaries electrical
Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features
and dimensions shown in the photographs and/or drawings.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp
objects.
This lamp is not intended for use with emergency exit fixtures or emergency lights.
For your safety read and understand instructions completely before starting installation.
Before attempting installation, check your local electric code, as it sets wiring standards
for your locality.
If luminaire (fixture) is to be switched from a wall switch, make sure black power supply wire
is connected to the switch. DO NOT connect the white supply wire to the switch.
Make sure no bare wires are exposed outside the wire nut connectors.
Do not make or alter any open holes in an enclosure of wiring or electrical components
during kits installation.
CCT Selector
MRL-S81815
Installation Guide:
Turn off the power before installation. Remove the
existing fixture if applicable.
Determine the location
and cut the ceiling
4. Place all wiring and connections back into the box
and close the cover. Connect the
DRIVER/JUNCTION BOX to the light panel using the
CONNECTOR.
5. Use the CCT selector switch on the outside of the
DRIVER/JUNCTION BOX to select the desired CCT
color of the light.
6. Insert DRIVER/JUNCTION BOX through the
mounting hole (Fig. 3) and secure using mounting
tabs.
7. Push the SPRING-LOADED CLIPS into the
mounting hole upwards and insert LIGHT PANEL into
it. Release the clips and the fixture will be pulled flush
to the ceiling. (Fig 4)
Black
Black
White
White
Green
Green
WARNING
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
CONSULTER UN ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE LES CONDUCTEURS DE LA
DÉRIVATION SONT ADÉQUATS.
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE
PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES
RISQUES INHÉRENTS