Instructions / Assembly

Undercabinet Light Install Guide
FIXTURE INSTALLATION
[e-mail] 866-MAXXIMA (629-9462) www.maxximastyle.com 125 Cabot Court Hauppauge, NY 11788
Before beginning assembly or installation of the lighting fixture, make sure all parts are present. Compare the
parts with the packaging contents listed on the following page. If any part is missing or damaged, do not attempt to
assemble, install or operate the fixture.
Estimated assembly time: 10-20 minutes (Installation time will vary depending on skill level and existing
wiring conditions).
Tools required for installation (not included): Philips head screwdriver, drill, measuring tape, pen/pencil/marker.
NOTE:
1. Before mounting the fixture, make sure that the fixture is within 5 feet of a 120V outlet.
Consider the path that the power cord will take when choosing a fixture mounting location.
2. This fixture is intended for installation on wood mounting surfaces such as a cabinet, wardrobe, bookcase, etc.
Step 1: Locate mounting holes: View the table above for mounting screw hole distances. Measure the distance
between the 2 screw slots on the light fixture. Find a suitable mounting location and mark the position where the
mounting screws will be installed. The screw holes must be exact for the fixture to mount properly.
Step 2: Drill holes and install screws: Caution: Check the cabinet thickness before proceeding. Be careful
not to drill through the cabinet. If mounting into wood, drill 1/16” pilot holes 1/2” deep. If mounting into drywall,
drill 3/16” holes for the plastic wall anchors. Insert the plastic wall anchors into the holes and carefully tap them
into place until they are flush with the surface of the wall.
Install the screws and leave them extended about 1/16” to 1/8” off of the surface. You may have to refine this
distance later on to ensure proper fitment of the light fixture onto the mounting surface.
Step 3: Attach fixture: Align the wide section of the keyhole slots underneath the fixture with the heads of the
mounting screws. (1) Push the fixture onto the screws. (2) Slide the fixture so the screws are secured into the
narrow part of the keyhole slots. If fixture is not sitting snug on mounting surface, adjust the screw depth as
described in step 2.
Step 4: Connect the power cord: Connect the 5’ power cord to the fixture. Plug the cord into a 120V outlet.
The light may be turned on or off using the toggle switch on the fixture. Warning: Do not conceal the power
cord inside a wall, ceiling, soffit, kitchen cabinet or similar permanent structure. Do not run the power
cord through holes in walls, ceilings or floors that may damage the cord.
MSL-12700W
MSL-18100W
MSL-24140W
www.maxximastyle.com
Model Number
MSL-12700W
MSL-18100W
MSL-24140W
Hole Distance
4 5/8 in.
10 5/8 in.
16 5/8 in.
1
2
Hole Distance