Full Product Manual

5
Installation
1.1 Installation Site Requirements
• Place the tub on a flat, stable surface that can bear the full weight of the tub when filled with
water and a person inside. Inadequate structural support may result in personal or property
damage.
• Only install your cold plunge tub on a waterproof floor to prevent water damage to your
surroundings. Failure to do so may result in property damage.
• Install the unit in a safe location that is not easily accessible to children. Ensure that the unit is
out of their reach and properly secured to prevent unauthorized access.
• Please ensure that the installation site provides easy access to a water source and water
drainage, and is waterproof. Adequate water access is necessary for filling and maintaining
your cold plunge.
Important Tips:
The ground should be smooth and flat, and there should be no sharp objects. Users should also consider
the total weight of the user, tub, and water to ensure that the ground has sufficient strength to support it.
Make sure there is a good water source and water drainage system close to the installation area. If the
tub is installed in a place that does not meet the safety requirements, then any loss caused will not be
covered by the warranty due to improper use by the consumer.
1) Indoor installation:
Some special requirements for indoor installation that need attention:
• During the filling and draining of water, water may spill on the ground. We strongly suggest that
the tub only be installed near floor drains and on water-proof surfaces.
• There should be no items nor appliances that are easily affected or damaged by moisture or
water in the immediate area around the tub. To ensure air quality and user comfort, the tub
must be installed in a well-ventilated environment.
Note: Do not install the tub on carpets or other surfaces that are easily damaged by water.
2) Outdoor installation:
• The ground where tub is on must be smooth and flat with no sharp objects such as branches
and stones nearby. Be sure to use the included floor mat for additional protection.
• Do not expose the tub to direct sunlight for prolonged periods of time. This will shorten the
service life of tub. We recommend covering the tub or placing it in a shaded area when not in
use.
• There should be a good water source and water drainage system near the tub.
1.2 Fill the tub with Water
Fill the tub with water using a water hose until there is sufficient water to be able to submerge your entire
upper body under water. Leave enough room for your head to be fully above the water line. In most cases
this would be at about 70% of the plunge pool.