Cold Plunge Chiller Manual Models: .6HP, .8HP, 1HP PERSONAL AND COMMMERCIAL USE 120 VAC 15 AMP DEDICATED CIRCUIT WITH GFCI OUTLET REQUIRED IMPORTANT: After unpacking (or accidental tip-over allow the chiller to stand upright for 20 minutes before starting. The fluid in the compressor needs to settle. Failure to do so could result in irrevocable damage not covered under warranty. Carefully and thoroughly read this owner’s manual before operating the system.
PRECAUTIONS: 1. Do not block or obstruct the cooling fans or vents of the chiller. This will affect the operation and efficiency of the chiller and possibly cause damage. 2. It is important to maintain and regularly check and clean the chiller and filter device. 3. To avoid personal injury or damage to the chiller, do not touch the fan during operation. 4. Make sure that the chiller is plugged into a circuit with the properly rated voltage. 5.
ASSUMPTION OF RISK ACKNOWLEDGEMENT As a condition of your use of the Dynamic Cold Therapy (the “Company”) website (the “Website”) and purchase of the Company cold plunges and products (the “Products”) you agree as follows under this Assumption of Risk Acknowledgement (the “Acknowledgement”): 1. Assumption of Risk. I know and understand the scope, nature, and extent of the risks involved in the use of the Products, including of sudden or prolonged exposure to cold water or heated saunas. (the “Activities”).
IMPORTANT INFORMATION 1.1 Pre-Install Checklist & Safety Warning Failure to adhere to the safety instructions and guidelines provided in this warning could result in serious injury or even death. Cold water immersion, electrical installation, and usage entail inherent risks that require careful attention and precautionary measures. o o o o o o o o o Dedicated Breaker: Warning: Use a dedicated circuit breaker for your cold plunge to prevent electrical overload.
1.2 Sanitation Warning: Safe Use of Ozone Important Information about Ozone Use and Safety Ozone generating systems play a crucial role in water treatment by introducing ozone gas into the water. It's important to understand the characteristics and precautions associated with ozone use to ensure the safety and effectiveness of water treatment processes. • • • • • • • Nature of Ozone: o Ozone is a gas composed of three oxygen atoms per molecule and can be readily dissolved in water.
1.3 Electrical Warning Important: The following electrical warning is intended to minimize electrical risks associated with the installation and use of your DCT Chiller. Please note that electrical codes and safety practices can vary based on your location. It is essential to follow the latest local electrical codes and regulations to ensure a safe installation. We highly recommend consulting a licensed electrician who is familiar with your area's codes and requirements for pools and spas.
1.4 Specs Model .6HP .8HP 1HP Power Supply AC 120V 60Hz AC 120V 60Hz AC 120V 60Hz Input Power 640W 725W 1150W Compressor Power 505W 630W 945W Cooling Capacity 1680W 2230W 2700W Heating Function Yes Yes Yes Refrigerant R410A R410A R410A Water Temp.
ASSEMBLY 2.
2.2 Packing List 1pc Cold Plunge Chiller & Spa System 1pc Filter Wrench 3pc 20 Micron Filter Cartridge 2pc Quick-Connect Hoses 2pc Hose Adapters 6pc Rubber Gasket Seals Note: Your cold plunge has been assembled and tested prior to packaging.
2.3 Assembly Details Step 1: Find a level surface for your chiller IMPORTANT: Allow the chiller to stand upright on a level surface for 20 minutes before starting. The fluid in the compressor needs to settle. Failure to do so could result in irrevocable damage not covered under warranty. Step 2: Apply teflon tape • Wrap Teflon tape clockwise 3x around the threads of both the inlet/outlet of the plunge bath, chiller, and valves.
2.4 Assembly Diagram No. 1 Chiller Inlet 2 Chiller Outlet Name No.
OPERATING THE COLD PLUNGE CHILLER & SPA SYSTEM 3.1 Control Panel Introduction 3.
3.3 App Set Up Note: Tuya can only support 2.4G WIFI signal. Before connecting your phone to the chiller, please confirm that the Wi-Fi___33 used by your phone is in the 2.4G frequency band. It will not be able to connect to the chiller, if it is in the 5G frequency band. Step 1: Add your chiller • Turn on your chiller. • Download the Tuya app. • Go into the settings menu on your chiller. • Press and hold the WIFI button for 3-5 seconds until the button begins to blink.
3.4 Settings & Preferences Step 1: Test your GFCI (reset) button o Locate the GFCI reset button on the back of your chiller. o After the unit it turned on, hit the reset button. o Test to make sure the unit properly shuts down / reboots. IMPORTANT: If the unit does not reset. Shut the unit off and contact support immediately. Step 2: Set a timer o We highly recommend setting your chiller on a timer. Reducing the runtime will dramatically improve the lifespan of your chiller.
3.5 Water Maintenance Step 1: Filling your plunge o For best results, it’s recommended that you fill your plunge with filtered water. In-line water hose filter attachments are readily available at local hardware stores, pool supply stores, and online at Amazon. Step 2: Turn on your ozone o It’s recommended that you set you ozone pump to run for 2 minutes – 5 minutes minimum. This frequency will efficiently help sanitize the water in your plunge.
3.6 Unit Maintenance Maintenance Checklist: • Regular cleaning: o Wipe down the exterior and fan regularly to prevent dust and debris from entering the system. o We highly endorse getting a small water vacuum to clean debris, especially for outdoor units. • Pump inspection: o Periodically inspect the pump for any signs of damage or abnormal noise. If it becomes noisy, or triggers a water flow malfunction, it’s likely time to replace your filter.
3.7 Troubleshooting My chiller won’t turn on • Try hitting the reset button on your GFCI adapter on the back of your chiller. • Try resetting your GFCI outlet. • Check the breaker in your home. Water flow failure • Replace your filter. When the filter is clogged it will often trigger this failure. • Clean your hair net strainer. Reference our YouTube channel for a detailed guide on how to clean out the hair strainer.
Warranty Information COLD PLUNGE CHILLER WARRANTY DYNAMIC COLD THERAPY warrants that the Cold Plunge Tub, purchased from an authorized agent and in its undamaged original packaging, is free from defects in materials and workmanship. DYNAMIC COLD THERAPY or its agent will, at their discretion, repair or replace parts that become defective within the warranty period, subject to the specific conditions below.
