Instructions / Assembly
Table Of Contents
- PRECAUTIONS:
- IMPORTANT INFORMATION
- 1.1 Pre-Install Checklist & Safety Warning
- 1.2 Sanitation Warning: Safe Use of Ozone
- 1.3 Electrical Warning
- 1.4 Specs
- ASSEMBLY
- 2.1 Product Diagram
- 2.2 Packing List
- 1pc Cold Plunge Chiller & Spa System
- 1pc Filter Wrench
- 3pc 20 Micron Filter Cartridge
- 2pc Quick-Connect Hoses
- 2pc Hose Adapters
- 6pc Rubber Gasket Seals
- Note: Your cold plunge has been assembled and tested prior to packaging.
- 2.3 Assembly Details
- 2.4 Assembly Diagram
- OPERATING THE COLD PLUNGE CHILLER & SPA SYSTEM
- 3.1 Control Panel Introduction
- 3.2 Interface Overview
- 3.3 App Set Up
- Note: Tuya can only support 2.4G WIFI signal. Before connecting your phone to the chiller, please confirm that the Wi-Fi___33 used by your phone is in the 2.4G frequency band. It will not be able to connect to the chiller, if it is in the 5G frequen...
- 3.4 Settings & Preferences
- 3.5 Water Maintenance
- 3.6 Unit Maintenance
- Warranty Information
- General Conditions:
2.3 Assembly Details
Step 1: Find a level surface for your chiller
IMPORTANT: Allow the chiller to stand upright on a level surface for 20 minutes before starting. The fluid in
the compressor needs to settle. Failure to do so could result in irrevocable damage not covered under
warranty.
Step 2: Apply teflon tape
• Wrap Teflon tape clockwise 3x around the threads of both the inlet/outlet of the plunge bath, chiller, and
valves.
Step 3: Connect your chiller to your plunge
IMPORTANT: Make sure the gasket is properly in place on your hose before connecting.
• Connect the “INLET” on your chiller to the “OUT” on your plunge bath with a quick-connect hose.
• Connect the “OUTLET” on your chiller to the “IN” on your plunge bath with a quick-connect hose.
• Hand tighten only.
NOTE: Once the hoses are attached you may fill your cold plunge bath.