Use and Care Manual

Figure 11

E. Installing the BENCH HEAT EMITTER PANEL and BENCH

1. Installing the BENCH HEAT EMITTER PANEL can be a little tricky. You will need to slide the

BENCH HEAT EMITTER PANEL into place at an angle as indicated in the pictures below. (see

Figure 12)

2. Plug in the BENCH HEAT EMITTER connector to the corresponding inlet located on the

SIDE WALL PANEL. Also plug in the FLOOR HEAT EMITTER PANEL. (see Figure 13)

connector to the corresponding inlet on the REAR WALL or SIDE WALL PANEL.

3. Install the BENCH at an angle as also seen in Figure 12. Then slide it over the horizontal bench

guides on the side panels. Slide the BENCH all the way in and against the REAR WALL PANEL.

Make sure to install the BENCH with the smooth and finished side facing upward. If screws were

provided, use them to screw down the bench. (see Figure 14)

Figure 12