Use and Care Manual

Note: Some sauna models are shipped with a spare TEMPERATURE SENSOR in case the

TEMPERATURE SENSOR is damaged in transit. The manufacturer decides this according to

sauna models and packaging.

I. Putting on the ROOF COVER

1. Place the ROOF COVER over the top of the sauna. Be cautious when pulling the power

cord through the hole in the roof cover. Gently place the ROOF COVER onto the ROOF

PANEL. When the edges are aligned, screw the ROOF COVER to the roof panel. (see

figure 21)

Figure

J. Optional MP3 Shelf

1. If your sauna comes with the optional MP3 shelf, use the two screws provided to mount the

self on either the side panels or front panel. (see figure 22)

Figure

Operating the Sauna

NOTE: Before the sauna is turned on, remove plastic protective covering from the

CONTROL PANELS. Please check and confirm that the connections to the POWER

SUPPLY, HEAT EMITTERS, CD/RADIO, and TEMPERATURE SENSOR are connected

properly. The power supply voltage and frequency must match the requested voltage

and frequency of the sauna (120VAC 15AMP Dedicated Circuit or 120VAC 20AMP

Dedicated Circuit).

Since many materials absorb the infrared rays, minimal clothing is recommended for

maximum effect. The infrared sauna emitters are designed to heat you and not