Use and Care Manual

12
I. Power Supply
The POWER SUPPLY is the control center of the sauna room. It is installed on the
rooftop and has inputs/outputs connected to it. (see Figure 1)
Figure 1
POWER IN - main power of the sauna room
HT1, HT2, HT3, HT4, HT5, HT6 heat emitter cords
LAMPROOF roof lamp power (optional)
LIGHTING chromotherapy lights
PANEL CONTROL control panel
FUSE RESET protects against power
II. Component Labeling
Power Cord Main power cord connects the POWER SUPPLY to the
dedicated wall outlet
HT1, HT2, HT3, HT4, HT5, HT6 Heater cords connect the heat emitters to
the POWER SUPPLY at these ports (HT5 & HT6 are not used on most
models)
Lighting Connects the interior lighting to the POWER SUPPLY at this port
LampRoof Connects the exterior roof lights to the POWER SUPPLY at this
port
Panel Control Connects the Control Panel through the CTRL harness to
the Power Supply at this port
L/R Speakers Connects the speakers through these wires to the Control
Panel
Temp Sensor Connects the Temperature Sensor through this wire to the
Control Panel