Manualshelf

Use and Care Manual

ManualsBrandsMaxxus ManualsHome SpasLifeSauna 2-Person Indoor Hemlock Infrared Sauna with 7 Ultra Low EMF Carbon Infrared Therapy Heaters and Sound System
11121314151617181920
17
Figure 11
5. Installing the REAR PANEL
A. Place the REAR PANEL up against the FLOOR PANEL. There will be a
molding at the bottom of the REAR PANEL that will rest on the FLOOR PANEL.
You may need to open up the RIGHT SIDE PANEL and LEFT SIDE PANEL to fit
the REAR PANEL between the two. Please note that the REAR PANEL will fit
with the RIGHT SIDE PANEL and LEFT SIDE PANEL like a puzzle as it inserts
into both side panels. Once the REAR PANEL is in place, you can buckle the
side panels to the REAR PANEL using the external buckles. (see Figure 12)
Figure 12
6. Installing the BENCH HEAT EMITTER PANEL and BENCH (Please note that
the BENCH and BENCH HEAT EMITTER PANEL do vary in installation and
design.)
Option 1
A. First, locate the BENCH HEAT EMITTER and slide it downward by aligning it
with the vertical guides on the side panels. The emitter grid will face outward
(toward the front of the sauna). Push the BENCH HEAT EMITTER PANEL all
the way down until it is resting on the FLOOR PANEL and secure in place.
B. Plug in the BENCH HEAT EMITTER connector to the inlet on the REAR
PANEL.