Use and Care Manual

C. Install the BENCH by sliding it over the horizontal bench guides on the side

panels. Push the BENCH all the way in until it touches the REAR PANEL and is

secured in place. Make sure to install the BENCH with the smooth and finished

side facing up.

Option 2

A. Installing the BENCH HEAT EMITTER PANEL can be a little tricky. You will

need to slide the BENCH HEAT EMITTER PANEL into place at an angle as

indicated in Figure 13. After the BENCH HEAT EMITTER PANEL is

installed, you can connect the BENCH HEAT EMITTER cord into the

applicable inlet on the REAR PANEL. Next, slide the BENCH over the

BENCH HEAT EMITTER PANEL. Make sure to slide the BENCH all the way

back. (see Figure 14)

Figure 13

Figure 14

*For model DYN-6209-03, you may need to remove the protection grid on the rear

wall panel to screw down the bench.

7. Installing the FRONT GLASS DOOR HANDLE

A. Next, the inner and outer door handles need to be mounted to the FRONT

GLASS DOOR. The natural finish side will need to be installed on the interior

side of the sauna room. The clear coat/stain finished side will be installed on the

exterior side of the sauna room. The screws will be used to mount the door

handle to the glass door.