Use and Care Manual

7. Speaker Noise

Solution: If you are hearing a humming noise from either speaker or both

speakers while the Bluetooth feature is connected with your musical device,

then there may be an issue with the control panel(s). To confirm this, please

connect your musical device using the MP3 AUX wire that came with the

sauna room to connect your musical device to the sauna speaker

system. You will connect one end of the MP3 AUX wire to your musical

device and the other end to the MP3 Jack on the ceiling. If the humming

sound can no longer be heard, then this confirms that the control panel(s) will

need to be replaced. Please contact Customer Service.

Solution: If you hear static noises from the speakers when no music is

playing, then be sure that the MP3 AUX wire is not plugged into the ceiling

port. You will have a constant noise coming from the speakers if one end of

the MP3 AUX wire is connected to the ceiling port and the other end is not

connected to anything.

8. Color Lighting

Solution: If your color light is not working, the issue with the light may have

to do with the connection on the top side of the light fixture. Please go up to

the roof panel and disconnect the wire connection on the topside of the light

fixture. Then reconnect the wire connection making sure that it is snug and

tight. Return back to the sauna control panel to test the light. If the light is still

having issues, please contact our Customer Service.

9. Dedicated Power Outlet

Solution: You have two options when it comes to a dedicate receptacle. You

have a true dedicated line if the receptacle is the only receptacle on the line

to the breaker in your electric panel box. You have a quasi-dedicated line if

you have multiple receptacles on a line to the breaker in your electric panel

box and you do not draw any power from the other receptacles when the

sauna is in operation. Both of these options are acceptable.

10. Lower Heat Emitters

Solution: With regards to the lower heat emitters under the bench and on

the floor, these heat emitters operate a bit different than the wall heat

emitters. As the bench heat emitter and floor heat emitter (200W/125W each)

are of much less wattage than the wall heat emitters (300W each), they will

not get nearly as hot as the wall heat emitter panels. We can have you run

two tests. First, remove the bench from the sauna room. Next, preheat the

sauna room by setting the temperature to the maximum of 151 degrees F