Full Product Manual

ManualsBrandsMaxxus ManualsCold PlungeDynamic Series 1-Person 1-Jet Round Cold Plunge Tub, Chills and Heats w/ Dual Filter System with Cover and Ground Mat

Table Of Contents

General Conditions

INTRODUCTION

Thank you for purchasing this Dynamic Cold Therapy Inflatable Cold Plunge Tub!

We hope you will enjoy your tub for many years to come!

To ensure your personal safety during installation and to get the most out of your investment, please

read this entire manual before beginning the installation process. If you feel that this process is too

difficult to do on your own, we advise that you seek assistance from a local building or home

improvement contractor.

Please note that this manual is for the Plunge Tub only. The User’s Manual for the Chiller is

separate and will be included with the optional Chiller.

Inflatable Cold Plunge Tub

Assembly Guide

WARNING:

Improper assembly and operation can result in severe personal injury as well as product

failure not covered by warranty. Please follow all instructions carefully or contact technical

support for assistance.

Summary of content (9 pages)

PAGE 1
Inflatable Cold Plunge Tub Assembly Guide INTRODUCTION Thank you for purchasing this Dynamic Cold Therapy Inflatable Cold Plunge Tub! We hope you will enjoy your tub for many years to come! To ensure your personal safety during installation and to get the most out of your investment, please read this entire manual before beginning the installation process.
PAGE 2
ASSUMPTION OF RISK ACKNOWLEDGEMENT As a condition of your use of the Dynamic Cold Therapy (the “Company”) website (the “Website”) and purchase of the Company cold plunges and products (the “Products”) you agree as follows under this Assumption of Risk Acknowledgement (the “Acknowledgement”): 1. Assumption of Risk. I know and understand the scope, nature, and extent of the risks involved in the use of the Products, including of sudden or prolonged exposure to cold water or heated saunas. (the “Activities”).
PAGE 3
___________________________________________________________________________ IMPORTANT SAFETY INSTRUCTIONS SAFETY AND OPERATIONAL WARNINGS • Before using this product, it is essential to read this entire manual and all instructions. This plunge tub is intended for use solely in the manner described in this manual. • Carefully inspect your cold plunge tub upon arrival for any signs of damage or leaks before filling it with water.
PAGE 4
PACKAGE CONTENTS Installation 1.1 Installation Site Requirements • • • • Place the tub on a flat, stable surface that can bear the full weight of the tub when filled with water and a person inside. Inadequate structural support may result in personal or property damage. Only install your cold plunge tub on a waterproof floor to prevent water damage to your surroundings. Failure to do so may result in property damage. Install the unit in a safe location that is not easily accessible to children.
PAGE 5
Important Tips: The ground should be smooth and flat, and there should be no sharp objects. Users should also consider the total weight of the user, tub, and water to ensure that the ground has sufficient strength to support it. Make sure there is a good water source and water drainage system close the installation area. If the tub is installed in a place that does not meet the safety requirements, then any loss caused will not be covered by the warranty due to improper use by the consumer.
PAGE 6
Screw the air valve cap on clockwise to lock it in place. • Deflation • • Open the cap of valve by turning counterclockwise. Press the red button in the center of the air valve so that it is in the down position and air starts coming out. (fig.2) fig.1 fig.2 Warning: Do not place your face in front of the air valve when pressing down on the red button or releasing air. Do not insert anything into the air valve or obstruct it in any way. 1.
PAGE 7
damage to the tub caused by too high or low pH value will not be covered by the manufacturer’s warranty. We suggest using pH test paper to routinely test the water quality before using it. 2.2 Water Treatment It is important to keep the water in the tub clean. The optional Dynamic Cold Therapy Chiller does come with a built-in particle filter and ozonator to keep the water in the tub clean. Please see the User’s Manual for usage instructions.
PAGE 8
clamp the patch to tub for maximum adhesion. Let the patch and glue dry for 24 hours before using the tub again. 2.5 Tub Storage Proper care and storage will prolong the service life of the tub. Before storing the tub, completely drain all water from the tub and wipe it down clean with a soft cotton cloth or towel. It is recommended to place the tub in the included storage bag and store it in a cool dry place.
PAGE 9
______________________________________________________________________________ WARRANTY DYNAMIC COLD THERAPY warrants that the Cold Plunge Tub, purchased from an authorized agent and in its undamaged original packaging, is free from defects in materials and workmanship. DYNAMIC COLD THERAPY or its agent will, at their discretion, repair or replace parts that become defective within the warranty period, subject to the specific conditions below.