Full Product Manual

5
Important Tips:
The ground should be smooth and flat, and there should be no sharp objects. Users should also
consider the total weight of the user, tub, and water to ensure that the ground has sufficient strength to
support it. Make sure there is a good water source and water drainage system close the installation
area. If the tub is installed in a place that does not meet the safety requirements, then any loss caused
will not be covered by the warranty due to improper use by the consumer.
1) Indoor installation:
Some special requirements for indoor installation that need attention:
• During the filling and draining of water, water may spill on the ground. We strongly suggest
that the tub only be installed near floor drains and on moisture-proof surfaces.
• There should be no items nor appliances that are easily affected or damaged by moisture or
water in the immediate area around the tub. To ensure air quality and user comfort, the tub
must be installed in a well-ventilated environment.
Note: Do not install the tub on carpets or other surfaces that are easily damaged by water.
2) Outdoor installation:
• The ground where tub is on must be smooth and flat with no sharp objects such as branches
and stones nearby. Be sure to use the included floor mat for additional protection.
• Do not expose the tub to direct sunlight for prolonged periods of time. This will shorten the
service life of tub. We recommend covering the tub or placing it in a shaded area when not in
use.
• There should be a good water source and water drainage system near the tub.
1.2 Tub assembly
Warning: Please only use the included hand pump to inflate the tub and do not over inflate it. Please do
not use other electronic or high-pressure air pumps for inflation. The normal working pressure of the
tub is 7psi. Excessive pressure will cause the tub to burst or damage the seams of the tub. The
maximum pressure for the tub is 9psi.
Inflation
• Unfold the tub on the ground to inflate it with the included hand pump.
• Open the cap of valve by turning counterclockwise.
• Press the red button in the center of the air valve so that it is in the up position. (fig.2)
• Insert the inflation hose into the air inlet and rotate it clockwise to lock it in place. (fig.1)
• Pump up the tub until the pressure gauge is between 6-8psi.
• Rotate the inflation hose counterclockwise to unlock it from the air valve. There will be a
short burst of air that is released.