Full Product Manual

6
• Screw the air valve cap on clockwise to lock it in place.
Deflation
• Open the cap of valve by turning counterclockwise.
• Press the red button in the center of the air valve so that it is in the down position and air
starts coming out. (fig.2)
fig.1 fig.2
Warning: Do not place your face in front of the air valve when pressing down on the red button or
releasing air. Do not insert anything into the air valve or obstruct it in any way.
1.3 Fill the tub with Water
Fill the tub with water using a water hose until there is sufficient water to be able to submerge your
entire upper body under water. Leave enough room for your head to be fully above the water line. In
most cases this would be at about 70% of the plunge pool.
Note: Overfilling the plunge pool will result in water spilling out and over the sides of the pool
when you enter. Please be mindful of any electronics, power cords, outlets, etc around the
plunge pool. We highly recommend starting with less water and then adding more as needed to
submerge your entire upper body.
1.4 Combination Locks
Please lock the combination lock and set the passcode when the tub is not in use.
The lock comes with the default passcode “00” which can be changed. Latch both ends of the lock
together and squeeze the sides of the latch. With both sides squeezed in, rotate the number dials to
your desired passcode. Once the desired passcode is set, release the sides of the latch to set the code.
Tub Maintenance
2.1 Water Maintenance
We recommend keeping the pH value of the water in the tub between 7.2 and 7.8. A pH value outside
of this range can shorten the service life of the tub and cause irritation or damage to your skin. Any