Owner`s manual

INSPECTION

You will want to inspect your spa, prior to lling it up with water. Look for

and remove any debris in the spa tub and in the lter. Verify that pump

plugs are installed on the pumps and the pump unions are tight.

FILLING THE SPA WITH WATER

NOTE: DO NOT ll your spa with hot water straight out of your water

heater or tap. This water may be as hot as 180 degrees F and will

cause damage to the surface and plumbing of the spa. This will void

your warranty. Level the spa before lling.

1) Prepare to ll the tub by removing all debris.

2) Remove the lters from your spa (see Removing, Installing and Clean-

ing Filters, page 42.)

3) Place your garden hose in the center of the lter as shown in the picture

below.

4) Fill the tub from the circulation pump line until water level is above

the foot-well.

NOTE: This will purge all the air out of the circulation pump. An air

lock can cause damage to the circulation pump and is not covered

under warranty.

SPA START-UP