Owner`s manual

MAINTAINING YOUR SPA

REMOVING, INSTALLING AND CLEANING FILTERS

These are the steps needed to successfully replace your lters You should

replace your disposable spa lters and clean your nondisposable lters

every four months.

1) Turn off all power to your spa and remove

the lter lid by lifting it out towards you.

2) Turn the lter counterclockwise and remove

it from the lter well.

3) Dispose of the used lter.

4) Place the new lter into position and turn clockwise to fasten. DO NOT

over-tighten.

5) Follow the directions 1) and 2) for the

pleated lter cartridge. You then rinse the

lter with a garden hose and soak the lter

in a mixture of one pint of lter cleaner with

2.5 gallons of water for at least 12 hours.

The lter must be completely submerged.

You then follow the directions 4) and 5) to

replace the lter.

WARNING: Power to your spa must be turned off prior to remov

ing your lters. The suction at the lter is extremely strong and can

cause injury if there is no lter. NEVER run your spa without the

lters properly installed. Injury to person and damage to the equip

ment can occur. Any damage to equipment due to this circumstance

will not be covered under warranty.

NOTE: You can upgrade your lter to a 75 Sqft. lter. Please see your

Artesian dealer, Part# 06-007-12 (standard) or 06-008-12 (Nature2)

option.