Owner`s manual

11
ISLAND SPAS DIGITAL CONTROL SYSTEM
The Island Spas touch
pad gives you complete control over
the functions of your spa. The
following section contains detailed
descriptions of each of the various
spa features and control buttons.
Please Note: Depending on which
spa you selected, you may or
may not have all the functions
described below.
Pump 1 Switch:
This key is used to turn the Pump on at Low, High, then Off (2-speed pump). If there is a
circulation pump, pump one will be one speed only, therefore, the pump one key will turn pump
on at High then off. A built-in 20 minutes timer will shut the pump off unless the user does so
manually. The Pump LED on the display will be on when the pump is running.
Note: that if there is a call for heat and the system is not using a circulation pump, the pump
cannot be turned off, and it will remain in Low speed.
Pump 2 Switch:
This key is used to start Pump #2 On/Off. The built-in 20 minute timer will shut the pump off
unless the user does so manually. On the display, the Pump #2 LED will be on when the pump is
running.
Light Switch:
This key is used to turn the light on and off. The first push of the light button will turn the light
on. Second push will turn the light off. A built-in timer will automatically turn the light off in 2
hours.
Temperature Arrows:
NOTE: Depending on your system (1-pump or 2-pump): you will have the temperature
arrows on one key (2-pump systems) or on two keys (1-pump systems).
1 Pump Systems: The “UP” arrow key will increase the water temperature by 1˚F (max. Temp
104˚F). The “DOWN” arrow key will decrease the water temperature by 1˚F (min. Temp. 59˚F).
2 Pump Systems: The first push of the “TEMP” key will raise the water temperature. Release and
push again to decrease. Please see 1 Pump Systems for increments.