Owner`s manual

16
REPLACING THE LIGHT BULB:
• Turn off the power at the main electrical service panel.
• Remove front access panel.
• Locate and remove the reflector by turning it counterclockwise until free from wall fitting.
• Remove the bulb from the holder.
• Replace with new bulb. Your Island Spas dealer has these bulbs in stock.
• Replace the reflector by screwing it clockwise back onto the wall fitting.
• Replace the front panel.
• Turn power on at the main electrical service panel.
NOTE: The spa light bulb is not covered under warranty.
MAINTAINING YOUR SPA CABINET:
The wood cabinet of your spa is stained and sealed with an oil-based acrylic stain. The stain is
formulated especially for spa cabinet and deck applications and is resistant to ultra-violet light
damage caused by sun rays. It is also resistant to fungus and insect damage. Your Island Spas
dealer carries this type of stain for your convenience, so call your dealer when you’re ready to
re-stain your cabinet. You should re-stain your wood cabinet at least once a year, or more
frequently, depending on the environmental conditions to which your spa is subjected.
Following is the wood cabinet re-staining procedure:
• Gently wash the cabinet with mild soap and water and allow to dry completely.
• Moisten a rag with the stain you have purchased from your Island Spas dealer.
• Apply the stain on the entire cabinet surface, wiping off any excess stain as you are applying.
• Allow to stain to dry for a minimum of 24 hours before getting the cabinet wet.
NOTE: Do not apply any solid type finish such as shellac or varnish. After weathering,
these types of finishes will crack and/or turn yellow. To refinish the wood if this happens,
you will have to completely strip the finish before applying the new one. Use only the stain
recommended by your Island Spas dealer for refinishing your spa.