Owner`s manual

square. A solid foundation is recommended as soon as possible.

INSPECTION

You will want to inspect your spa, prior to lling it up with water. Look for

and remove any debris in the spa tub and in the lter. Verify that pump

plugs are installed on the pumps and the pump unions are tight.

FILLING THE SPA WITH WATER

NOTE: DO NOT ll your spa with hot water straight out of your water

heater or tap. This water may be as hot as 180 degrees F and will

cause damage to the surface and plumbing of the spa. This will void

your warranty. Level the spa before lling.

1) Prepare to ll the tub by removing all debris.

2) Remove the lters from your spa (see Removing, Installing and

Cleaning Filters, page 41)

3) Insert the hose in the area where the lter was located as shown in the

picture below.

4) Fill the spa to the bottom of the pillows.

NOTE: DO NOT OVER-FILL YOUR TUB!

5) With the front panel off, verify there are no leaks at the pump union.

NOTE: Pump unions can become loose during shipping. Verify that

there are no leaks during lling of the spa.

6) Replace both lters.