Owner`s manual
IMPORTANT SAFETY INSTRUCTIONS
PLEASE TAKE THE TIME TO READ ALL OF THESE WARNINGS
AND CAUTIONS PRIOR TO USING YOUR SPA.
PLEASE, be a responsible spa owner. When installing and using this
spa, always adhere to basic safety precautions. Be sure to list emergency
telephone numbers at the telephone nearest the spa, including physician,
hospital, ambulance, police, and the re department. Be certain to explain
safety precautions to all new or occasional users of your spa. Remember,
they may not be aware of the possible risks associated with the spa water
temperature. Have at least one family member learn CPR (cardiopulmo-
nary resuscitation). IT COULD SAVE A LIFE!
READ AND FOLLOW ALL INSTRUCTIONS
1. WARNING - To reduce the risk of injury, do not permit children to use
this product unless they are closely supervised at all times.
2. A wire connector is provided on this unit to connect a minimum 8 AWG
(8.4 mm) solid copper conductor between this unit and any metal equip
-
ment, metal enclosures of electrical equipment, metal water pipe, or
conduit within 5 feet (1.5 m) of the unit.
3. For cord connected/convertible units. DANGER - Risk of Injury -
a) Replace damaged cord immediately.
b) Do not bury cord.
c) Connect to a grounded, grounding type receptacle only.
4. DANGER - Risk of Accidental Drowning - Extreme caution must
be exercised to prevent unauthorized access by children. To avoid ac
-
cidents, ensure that children cannot use this spa unless they are super-
vised at all times.
5. DANGER - Risk of Injury - The suction ttings in this area are sized
to match the specic water ow created by the pump. Should the need
arise to replace the suction ttings or the pump, be sure the ow rates
are compatible.
Never operate spa if the suction ttings are broken or missing. Never
replace a suction tting with one rated less than the ow rate marked on
the original suction tting.
6. DANGER - Risk of Electrical Shock - Install at least 5 feet (1.5 m)
from all metal surfaces. As an alternative, a spa may be within 5 feet
of metal surfaces if each metal surface is permanently connected by a
minimum 8 AWG (8.4 mm) solid copper conductor to the wire connector
on the terminal box that is provided for this purpose.
1