User manual

First Start > Graphic User Interface

Manual for C11

d) Navigation within screens

Elements inside of the screen can be reached by pressing the cursor buttons.

Direction of the cursor buttons corresponds to the navigation direction on screen.

e) Backspace functionality (delete character/text )

Holding the

button pressed for approx. 2 seconds changes to delete mode.

First character is deleted after approx. 0.5 seconds but the delete speed is

increased for 10% for each further character.

2.6

Switching On and Off

The models without front panel controls are switched on

automatically as soon as power supply is available.

For models with front panel controls:

a) Soft switching on/off

Press and hold the F4 button for approx. 2 seconds to switch on C11.

To prevent accidental switch off this must be done either

· via front panel menu item System/Switch off

· or by holding the F4 button for approx. 2 seconds to open the 'Switch Off'

dialog

b) Hard switching on/off

Usually this means connecting or removing power supply e.g. plug or unplug

power supply connector. However, hard switching off can be also done by holding

the following key combinations for approx. 4 seconds: cursor button € and '0'.

Note:

C11 'remembers' the last power state i.e. if C11 has been turned off by removing

power supply it starts up automatically as soon as power supply is back.

2.7

Useful Hints

2.7.1 Default IP settings

a) By default every C11 has got the following IP settings:

· DHCP: off

· Address: 10.0.0.10

· Netmask: 255.255.255.0

· Gateway: 255.255.255.255

· DNS Server: 255.255.255.255

Advanced Dual IP Audio Codec C1190/901 has got two Ethernet cards with

different default settings.

· LAN1 (the upper one, by default only used for audio streaming)