User manual

Individual Parameters
30 © MAYAH Communication GmbH
To set the encoder, proceed as follows:
(a) Via the front panel:
• Select the SETUP option in the Start mask (see Figure 4). The Setup mask appears.
• Select AUDIO ENCODER and press . The following mask appears:
Figure 21: The ENCODER mask
• Select the parameter to be changed with the and keys and then press the
key. A list of all possible values appears.
• Select the desired value with the and keys and then press the key.
• Repeat this procedure if required for additional parameters.
• End the setting by pressing the key.
(b) Via the remote control software:
• Select SETTINGS CODEC. The following dialog window opens:
Figure 22: The CODEC SETTINGS dialog window
• Select the desired value the individual encoder lines.
Note: The selection options for the decoder are explained in section “Set Decoder”.
• To make the settings effective, click on ”OK”.