User manual

Table of Contents
Centauri user manual revision level 01 /2007
31
5.1.2. Set Decoder
You can pre-set the decoder with 2 operational modes:
– Dependency: ”remote”; to this the decoder sets itself to the parameter that it receives
from the distant encoder when the connection is made;
– Dependency: ”local”; with this the decoder uses the locally set parameters;
To set the decoder, proceed as follows:
(a) Via the front panel:
• Select the SETUP option in the Start mask (see Figure 4). The Setup mask appears.
• Select AUDIO DECODER and press . The following mask appears:
Figure 23: The DECODER mask
• Select the parameter to be changed with the and keys and then press the
key. A list of all possible values appears.
• Select the desired value with the and keys and then press the key.
• Repeat this procedure if required for additional parameters.
• Exit the parameter setting function by pressing the key.
(b) Via the remote control software:
• Select SETTINGS CODEC. The following dialog window opens:
Figure 24: The CODEC SETTINGS dialog window
• Select the desired values under DECODER .....
It is only possible to set the decoder parameter if ”Dependency” is set to ”local”.
• To make the settings effective, click on ”OK”.