User manual

Table of Contents
Centauri user manual revision level 01 /2007
35
5.1.6. Set Device Address
You can assign the MERK II an address.
Attention!
For operational security reasons an IP address should only be entered manually in
agreement with the network administrator. Setting the IP address yourself can lead
to system disturbance.
To enter the address, proceed as follows:
(a) Via the front panel:
• Select the SETUP option in the Start mask (see Figure 4). The Setup mask appears.
• Select NETWORK and press . The following mask appears:
Figure 30: The COMMUNICATION INTERFACE mask
• Select the ADDRESS parameter with the and keys and press the key.
• Enter the desired address using the and
*)
keys, as well as the numeric keys,
and then press the key.
• Repeat this procedure for each address which needs to be changed.
• Exit the address setting function by pressing the key.
(b) Via the remote control software:
• Select Settings Network. The following dialog window opens
Figure 31: The Network Configuration dialog window
• Enter the address.
• Click on OK.
The entered IP address is now transmitted to the MERK II and entered there.
• For reasons of communication security you should now close the remote control soft-
ware and restart.
• Switch off the appropriate MERK II and switch it back on after a few seconds.