User manual

Table of Contents

Centauri user manual revision level 01 /2007

5.1.11. Switch Dual Mode On/Off

Dual Mode must be switched on if bilingual sound is to be transmitted or if a completely

separate transmission is to be made to different destinations over two channels. To switch

Dual Mode on or off, proceed as follows:

(a) Via the front panel:

• Select the SETUP option in the Start mask (see Figure 4). The Setup mask appears.

• Select MISCELLANEOUS and press The MISC mask appears.

Figure 41: The MISC mask

• Select DUALMODE with the and keys and press .

• Enter the desired value with the and keys and press .

• To end press the key.

(b) Via the remote control software:

• To switch the Dual Mode on or off, select SETTINGS OTHERS in the remote control

software. The following dialog window opens:

Figure 42: Additional settings

• Select the desired value under “Dual Mode at B-channel”.

• To make the new value effective, click on “OK”.

For Dual Mode only mono and sample rates <= 32 kHz can be used.