User manual

Table of Contents
Centauri user manual revision level 01 /2007
59
6.5. Indications
The Merk II is able to react to internal and external events.
There is more about this topic on page 9.
6.6. Cut Connection
You can cut an existing connection at any time.
(a) Via the front panel:
In order to break off an existing connection, proceed as follows:
1) Via the start mask
• Select CONNECT in the start mask (see Figure 4) and press the key.
• Now select DISCONNECT and press the key once again.
2) Via the speed dial key
• Press the *) key. The SPEED DIAL mask appears.
Figure 67: The SPEED DIAL mask
• Select DISCONNECT and press the key once again.
The connection is broken off immediately. All of the channels utilized by the connection
are closed, i.e. both B channels of a two-channel ISDN connection.
(b) Via the remote control software:
• To cut an existing connection, click DISCONNECT in the program window. The connec-
tion is cut off immediately. All the channels belonging to a connection are closed, i.e. in
the case of a two-channel ISDN connection, both B channels.
Figure 68: Disconnect dialog mask, if several connections exist
Note: One separate connection can be displayed up to a maximum of 49.7 days (this
value depends on the type of cardinal variable in which it is stored, exactly 2
32
– 1 ms).