Installation Guide

PRODUCT INSTALLATION
BOMBAY COLLECTION
REV 111715
PRODUCT INSTALLATION
4
INSTALLATION (continued)
4
Installing the faucet to the vanity top
Follow the manufacturer's instructions to install the faucet
and drain assembly to the vanity top.
5
Securing the vanity top
□ Place the vanity top (C) with the pre-installed sink
(D) over the vanity (A).
□ Make sure the wall is straight and there are no gaps
between the wall and vanity top (C).
□ Remove the top (C) and apply a small bead of
silicone compound to the top of the vanity before
the vanity top is set into position.
□ Firmly press the vanity top (C) into position; check
the level and evenness across the front of the vanity
(A), and make sure the vanity top (C) is ush to the
wall.
□ Apply silicone compound to the back and bottom
of the backsplash (B). Firmly press the backsplash
(B) to the vanity top (C) to set into place, then rmly
press the backsplash (B) to the wall.
6
Reconnecting the water supply
□ Install the 4 round pegs (BB) into the pre-drilled
holes inside the vanity.
□ Slide the wooden shelf over the round pegs (BB).
□ Reconnect the faucet supply lines to the water
supply and reconnect the p-trap.
□ Install the pop-up drain.
□ Turn on the water supply or the home’s main water
supply and test for leaks.
D
A
C
B