Installation Guide

ManualsBrandsMaykke ManualsBathBombay 60.5 in. W x 22 in. D Vanity in American Walnut with Granite Vanity Top in Black with White Basin

PRODUCT INSTALLATION

BOMBAY COLLECTION

REV 111715

PRODUCT INSTALLATION

60in VANITY COMBO

PRE-INSTALLATION

Tools Required

Rubber mallet Safety goggles

Phillips

screwdriver

Level

Silicone

Compound

Hardware Included

Part Description Quantity

AA Leg levelers (pre-installed on legs) 4

BB Round pegs for shelf 4

Description Quantity

Wood screws 2

2” x 6” lumber (cut to t between studs) 1

5/16” Lag Bolts (min. 250lbs) load bearing 2

Washers for Lag Bolts 2

Materials Required

WHAT IS COVERED

All products in the package carry a One-Year Limited Lifetime warranty. This warranty applies only to the original

purchaser and to the original installation of the product.

WHAT IS NOT COVERED

Damage caused during moving or during installation is not a defect or warranty issue and will not be considered as such.

This warranty does not cover product failure caused by abusive treatment, surface scratches, misuse, neglect or damage

due to handling or faulty installations. All wood naturally ages, darkens, changes in color, and mellows over time due

to exposure to light. While this color change is imperceptible from day to day, it may be signicant over a long period of

time, or due to amount of light the wood is exposed to. Imperfections such as small surface splits, small dark holes or

darker mineral streaks are natural and are not considered defects.

Toll free Customer Assistance at 877.659.2128

M - F: 7:30AM - 4:30PM PST.

LIMITED LIFETIME WARRANTY

MODEL: D24960

Summary of content (7 pages)

PAGE 1
BOMBAY COLLECTION PRODUCT INSTALLATION 60in VANITY COMBO MODEL: D24960 LIMITED LIFETIME WARRANTY WHAT IS COVERED All products in the package carry a One-Year Limited Lifetime warranty. This warranty applies only to the original purchaser and to the original installation of the product. WHAT IS NOT COVERED Damage caused during moving or during installation is not a defect or warranty issue and will not be considered as such.
PAGE 2
BOMBAY COLLECTION PRODUCT INSTALLATION PRE-INSTALLATION (continued) Package Contents B C D A Part Description Quantity A Cabinet body 1 B Backsplash 1 C Stone vanity top 1 D Vitreous china sink 1 INSTALLATION 1 Tracing the outline of the vanity Determine the ideal location for your new bath furniture. □□ Trace its outline on the wall. □□ Use a stud finder to locate the studs to which you will attach the vanity.
PAGE 3
BOMBAY COLLECTION PRODUCT INSTALLATION INSTALLATION (continued) 2 Installing support for vanity Provide 2x6 backing material behind the finished wall to properly support the vanity. □□ To properly secure the vanity, the middle of the required 2x6 backing material must be 31-1/4” (793mm) from the finished floor. □□ Extend the backing material beyond the width of the vanity to the nearest stud. This will ensure proper support for the vanity.
PAGE 4
BOMBAY COLLECTION PRODUCT INSTALLATION INSTALLATION (continued) 4 Installing the faucet to the vanity top Follow the manufacturer's instructions to install the faucet and drain assembly to the vanity top. 5 Securing the vanity top □□ Place the vanity top (C) with the pre-installed sink (D) over the vanity (A). B □□ Make sure the wall is straight and there are no gaps between the wall and vanity top (C).
PAGE 5
BOMBAY COLLECTION PRODUCT INSTALLATION DOOR ADJUSTMENT LEFT TO RIGHT If the gap between the door and vanity side panel needs adjustment, turn the screw closest to the door clockwise or counter clockwise. vanity side panel Make sure to adjust both the top and bottom hinges to keep the door level. door FRONT TO BACK If the door is not aligned perfectly with the vanity frame, turn the screw closest to the vanity side panel clockwise or counter clockwise.
PAGE 6
BOMBAY COLLECTION PRODUCT INSTALLATION DRAWER ADJUSTMENT UP AND DOWN If the gaps above or below the drawer need adjustment, simply turn the screw that is mounted to the glide of the drawer box. By loosening the screws this gives the drawer box freedom to move up or down. Remember to tighten the screws after the drawer box is in place. FRONT TO BACK If the drawer is not aligned with the vanity frame, pull the drawer out to its furthest point to reveal the screw closest to you.
PAGE 7
BOMBAY COLLECTION PRODUCT INSTALLATION CARE AND CLEANING WOOD DOORS AND PANELS Dust cabinets frequently with a soft, lint-free cloth. You may dampen the cloth with water or with a spray-type dust remover. Clean up spills immediately. Use a clean, damp cloth if necessary. Wipe dry with another clean soft cloth. Cloth is better than paper towels for this purpose.