End Table Assembly Instructions Product Dimensions: 15.75”Lx11.75”Dx20.75”H*53 cm Please take a moment to read through the entire instruction booklet before assembly to familiarize yourself with this product. Once you feel ready to start, follow the instructions step by step and this should make this process as easy as we could make it for you.
WARNING ! CAUTION ADULT ASSEMBLY REQUIRED CHOKING HAZARD • This product includes small parts, sharp points and sharp edges in its unassembled state. Keep unassembled parts away from children under 3 years of age, and animals. STRANGULATION HAZARD • Never attach or hang items to any part of the bookcase that is not designed for use with the bookcase; for example, but not limited to hooks, belts, and jump ropes.
ASSEMBLY AT A GLANCE Please take a moment to read through the whole instruction booklet before assembly to familiarize yourself with this product. Once you feel ready to start, follow the instructions step by step and this should make this process as easy as we could make it for you. Due to the number of parts involved assembly can take a few hours so set aside between 30 minutes and 1 hour to assemble this without rushing.
COMPONENT PARTS Please check that you have all the parts listed below 1 1. Table Top Panel x1 2. Middle Panel x1 3. Bottom Panel x1 4. Left Shelf x1 5. Right Shelf x1 6. Drawer Front Support x1 7. Drawer Left Side x1 8. Drawer Right Side x1 9. Drawer Rear Support x1 10. Drawer Bottom x1 11.
ASSEMBLY INSTRUCTIONS 1 Select 7,8,9,10 and A x8. Align groove in 7, and 8 to groove of 9. Fasten 7 to 9 with A x2. Repeat and fasten 8 to 9 with A x2. Slide drawer bottom 10 into groove of 7, 8 and ensure snug into 9. A 8 9 10 A 7 2 Select 6, Ax4, Cx1, Dx1. Align groove of 6 to 7 and 8. slide 10 into groove of 6. Insert Ax2 into holes at end of 7 and fasten 6 to 7. Repeat Ax2 into holes at end of 8 and fasten 8 to 6. Insert D bolt inside 6 and fasten to C drawer pull.
ASSEMBLY INSTRUCTIONS 3 Select 2, 3, 4, 5, 11, A x4, B x6. Position 3 in the bottom, position 2 in the middle with groove facing up toward top of unit. Insert B x2 into center holes of 3. Insert B x4 into holes in 2. Align 4 to the left and 5 to the right of the center shelves. Insert dowels from 2 and 3 into holes of 4 and 5. Fasten 3 to 4 and 5 with 4 A x4. Loosely tighten the A screws to allow adjustment at top. Align 11 into groove of 2, 4 and 5. Tighten A screws in 3.
ASSEMBLY COMPLETE CONGRATULATIONS, YOUR NIGHTSTAND/END TABLE IS COMPLETE! Page 7 of 7
