Manual

NOTE: If installing a table without access panels (7 &
8), proceed to Step 5.
4. Attach mounting angles (E12) to trough side (3)
using screws (E13) in locations shown.
5. Install screws (E4) to the inside of leg (the side opposite gusset
flange) and to the vertical members of the corner connector (5),
leaving approximately 1/8" between screw head and leg /corner
connector members.
6. Using slots in trough sides (3), hook trough sides onto screw
heads on legs and corner connector. DO NOT TIGHTEN SCREWS.
NOTE:
If using a power pole, install power pole to corner connector (5) at
this time and position as desired. Use instruction sheet and
hardware included with Power Pole product.