Manual

NOTE: If installing a table without access panels (7 &
8), proceed to Step 8.
7. Attach mounting angles (E12) to beam assembly
(2) using screws (E13)
8. Install beam assembly (2) from above. Position
beam with end notch as noted in detail at right. Place
beam (2) between legs (1) and corner connector (5) by
tipping the beam into the leg flange notch. Secure beam
(2) with screws (E4) and washers (E5).
9. Insert bushing (E9) into trough side (3) and corner
connector (5).
10. Tighten all screws (E4) at this time.
Note:
"Notch" in Beam Assembly (2)
toward Corner Connector (5)