Manual

11 Lay pan (4) onto inside trough side flanges (3).
Secure pan (4) to trough sides (3) using pine tree clips
(E11).
12. Install slam latch (E8) into inner leg panel (10 &
11) as shown.
13. Insert tabs in the bottom of inner leg panel (10 or
11) into slots in leg (1) or corner connector (5). Rotate
inner leg panel (10 or 11) up so that slam latch catches
flange on pan (4).
14. Install outside leg panels (9) by aligning one
flange with the inside edge of the tube and applying
pressure to create a curve in the end panel that allows
2nd flange to slide inside edge of tube.
15. Insert square hole plugs (E7) and pine tree clips
(E10) into holes in beam (2). NOTE: This step should be
done after privacy panels or monitor posts are installed in
the beam.
&