User guide

ManualsBrandsMayline ManualsFurnitureAcrylic Panels

COMPONENTS:

REF. # QTY. DESCRIPTION PART No.

1 1 ACRYLIC PANEL CALL~~**

2 2 CLAMP ASSEMBLY A8058**

HARDWARE BAG (PART No. A8111)

*for individual item, order that part number

REF. # QTY DESCRIPTION PART No.

E1 2 5/16-18 x 5/8" X440*

E2 1 5/16-18 x 3/8" X385*

E3 1 1/4-20 x 5/8" X404*

E4 1 1/4-20 T12*

ASSEMBLY INSTRUCTIONS

TRANSACTION LATERAL ACRYLIC

PANELS

NOTE: Please count and inspect all pieces before disposing of any carton or packing materials.

When ordering components, specific color and/or size information may be required.

Contact a Mayline Customer Service Representative. 1-800-822-8037

** Denotes Color Code

~~Denotes Size

BETTER FOR YOUR BUSINESS

(1)

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS TRANSACTION LATERAL ACRYLIC PANELS NOTE: Please count and inspect all pieces before disposing of any carton or packing materials. COMPONENTS: REF. # 1 2 QTY. 1 2 When ordering components, specific color and/or size information may be required. Contact a Mayline Customer Service Representative. 1-800-822-8037 DESCRIPTION PART No. ACRYLIC PANEL CALL~~** CLAMP ASSEMBLY A8058** ** Denotes Color Code ~~Denotes Size HARDWARE BAG (PART No. A8111) REF.
PAGE 2
1. With clamp screws loose, attach Clamps (2) to table beam using Screws (E1) in the desired locations. 2. Slide Acrylic Panel (1) into Clamps (2). 3. Secure panel by tightening clamp screws.
PAGE 3
ASSEMBLY INSTRUCTIONS TRANSACTION ACRYLIC DIVIDER PANELS NOTE: Please count and inspect all pieces before disposing of any carton or packing materials. COMPONENTS: REF. # 1 QTY. 1 2 1/2 3 1 When ordering components, specific color and/or size information may be required. Contact a Mayline Customer Service Representative. 1-800-822-8037 DESCRIPTION PART No. ACRYLIC PANEL CALL~~** CLAMP ASSEMBLY J24 OFFSET PLATE B8356** ** Denotes Color Code ~~Denotes Size HARDWARE BAG (PART No. A8111) REF.
PAGE 4
For table seam location: 1. Attach Clamp Assemblies (2) to each end of the Acrylic Panel (1) at notch by sliding panel into Clamp Assembly (2) and tightening screws. 2. Attach center Clamp Assembly (2) to Offset Plate (3) using Screw (E3) and Nut (E4). Note: Clamp Assembly screws may need to be loosened to allow for screw to fit into Clamp assembly and attach to the beam. Next steps vary depending on location of panel. For table end location: 2.