User Manual

NOMAD - LK4 -2
O
PERATING
I
NSTRUCTIONS
P
AGE
3 of
3
1. IMPORTANT INFORMATIO N
FCC ID:
OOALK4 -2
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Warning!
Any modification or changes made to this device, unless explicitly
approved by Maynetronics Limited, will invalidate the authorisation of this
device. Operation of an unauthorised device is prohibited under Section 302
of the Communications Act of 1934, as amended, and Subpart I of Part 2 of
Chapter 47 of the code of Federal Regulations.
2. INTRODUCTION
The LK4-2 link unit is a remote transceiver for the NOMAD system. Its
purpose is to provide the radio link to wi reless NOMAD terminals.
Several of these link units can be connected to the same controller via a
single twisted pair cable. Each link unit is powered from a 12V DC supply.
3. SPECIFICATION
Power 10 -18V DC
Average Consumption 100mA
Radio link
Fre quency 915MHz
3.1 CERTIFICATION
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful