User Manual

NOMAD™ - NRT102
OPERATING INSTRUCTIONS
PAGE 8 of 10
Press the ‘ENT’ key when desired job code is displayed. Further prompts
may be displayed requesting the user to in turn enter any additional
parameters required by the job code. For example, after pressing ‘ENT’ for
“Clock In” the user is prompted for “Operator” and should enter their works
number.
The number of digits that the terminal will accept will vary depending on the
parameter and the setting made in the NOMAD system.
Note that the terminal will only accept codes other than “Clock In” (code 0) if
the user has clocked in. Once clocked in the prompt for code 0 will change
to “Clock Out”. After pressing enter to “Clock Out” the user will be prompted
to “Confirm”. This is done by pressing the ‘ENT’ key again.
5.2 MULTI-USER MODE
To exit the standby mode press and hold the 4 and the 6 keys together. A
prompt inviting the user to “Enter Operator” will be displayed.
Enter the operator number for the job to be entered and press ‘ENT’. A
prompt inviting the user to “Enter Time” will be displayed.
The current time will be display in the lower right corner of the screen. To
accept this press the ‘ENT’ key, else key in the required time and press the
‘ENT’ key.
The rest of the process is as per section 5.1 above.
6. ERROR MESSAGES
6.1 CLOCK NOT SET
If the internal clock has not acquired the current time from the NOMAD
system then an error message will be displayed “CLOCK NOT SET”. If this
message is displayed ensure that the terminal is within range of a link unit to
allow the terminal to acquire the time. Once the time is acquired the internal
clock of the terminal will maintain the time until power is lost.