User's Manual

25
26
5. Mobile Phone Software Visit
Home Security Begins at the Tuya Smart
Your new security products are start of Tuya Smart around your entire property.
Now, you’ll always be connected to your home, so you can watch over your property and answer it
from anywhere.
5.1 Download Tuya Smart app
The Tuya Smart will walk you through setting up and managing your all security products.
Search for “Tuya Smart” in one of the app stores, android in “Play Store”, and IOS in “App Store”.
5.2 WIFI setting
Note:
1). Router Band--This IP indoor monitor will only connect to the 2.4GHZ band. If you have a
dual-band router, you must create unique SSID for the 2.4GHZ and 5GHZ bands. Prior to
initiating the syncing process, make sure your device is connect to the 2.4GHZ SSID.
2). Router b/g/n --This IP indoor monitor works on 802(b/g/n) network.
Grab your Wi-Fi password
It’s required for the in-app setup.
Write it down below so it’s handy when you need it;
Your Wi-Fi password
Select registration region.
Email is your available email account.
Password requires at least 6~20 characters
with a mix of letters and numbers.
5.3 Sign up an account
5.4 Set up IP Indoor Monitor
5.4.1 Wired network
User can connect the indoor monitor through network cable, operation steps:
1. Connect a network conversion with 4 pin interface to net port on the indoor monitor, and connect the
keystone jack of network to the end of the 4 pin interface.
2. Connect the outdoor camera(s) and CCTV camera(s) to the indoor monitor through 4 pin line(s), and
the CCTV cameras must use external power switching.
3. Power on the monitor, wait for a white until the screen shows the screen saver, then the indoor
monitor starts completely.
Network connection diagram through wired network of Figure 1 as an example.
Step 1. Connect your smart-phone to the WiFi router which you want the IP indoor monitor to be
connected to.
Step 2. Connect the IP indoor monitor to the same WiFi router.
Note: Please make sure the WiFi router and your smart-phone are both connected to the Internet.
Step 3. Set the “net pairing mode” of the monitor to “Cable”. Enter the “Setting->Network
setting” menu interface and change the “Net pairing Mode” to “Cable”.
After choosing “Cable” and press “ ”, the following window will pop up, press “Ok”, the
monitor will auto-reboot. After the monitor restarts, it will enters the cable net paring mode, and
the monitor will obtain an IP address.
Network setting
Net pairing Mode
Cloud services
IP address
MAC
Cable
Unconnected
a0:9f:10:73:13:01
Restart system
Ok
Cancel
<
<
Network setting
Net pairing Mode
Cloud services
IP address
MAC
Cable
Unconnected
192.168.50.108
a0:9f:10:73:13:01
<
<
Figure 1
Internet
Reset
WAN
LAN
AC/DC power
lock
(not Included)
(not Included)
4C
3G/4G/WIFI
IOS/Android
To WAN
To LAN
To LAN
Router
IP Indoor Monitor
Modem
AC/DC power
lock
(not Included)
(not Included)
4C
DOOR1 DOOR2
WIFI(LAN)
IOS/Android
WIFI(LAN)
CAM1
CAM2
4C
Power adapter for
camera(not included)
Power adapter for
camera(not included)
4C