User's Manual

2. Set System Parameters On Indoor Monitor
Attention before using:
1. This indoor monitor displays the OSD menu on its own screen, and the user can set all the
parameters on the indoor monitor.
2. The user can use the "Tuya Smart" application to connect to the indoor monitor via android
system or IOS system mobile phone/tablet.
3. The motion detection function only supports one channel, which means that when the motion
detection function of door 1 is activated, the motion detection function of the other channel
cannot be activated at the same time. User can set up the motion detection parameters on the
indoor monitor menu.
4. User can insert a TF card to store video records, audio records and photographs, supports up
to 256GB. All the recordings and photographs are be stored in the TF card of the monitor. If
the TF card capacity is less than 64GB, the file system format of the TF card must be Fat32,
and the user can format the TF card on the monitor before use. If the TF capacity is greater
than or equal to 64GB, the file system format must be exFat, and the user must format the TF
card on the computer before using. And it is recommended to use a TF card with a writing
speed greater than Class 10 on the device.
5. When the indoor monitor is ready in AP mode, the WIFI hotspot of the monitor can be searched
in the WIFI list of the mobile phone.
6. If the user doesn’t perform any operate or enter any interface of the indoor monitor, the indoor
monitor will automatically enter standby mode after 1 minute.
7. Press “ ” or “ ” to modify the parameters.
8. After modifying the parameters, the settings will be saved when the monitor is in standby
mode.
MENU OPERATIONS
In standby mode, touch the screen anywhere to access the main menu interface, shows the main
interface as shown below. On menu settings, touch any icon to enter next menu interface. On sub-menu
settings, press “ < ” or “ > ” to modify the parameters, and press “ ” to exit current menu interface.
<
<
Monitoring Transfer Recording
Setting At home Lock
2021-11-16 12:24
Standby Mode
NOTICE：
In internal communication mode, if a visitor
press the call button on either of outdoor unit,
the internal communication mode will be
switched off. The just visitor’s image will appear
on its screen and continuous ringing will be
heard, the user can press the talk button to
reactivate conversation with the visitor.
Touch the screen anywhere to
bring up the main menu.
Touch the “ ” icon on the master
to call the “Slave 1” monitor.
Press “ ” to start conversation
between the master and the slave 1.
Press “ ” on the master or “ ”
on the slave 1.
A continuous
ring tone is
heard on the
slave 1.
B. This IP indoor monitor supports the directional call function, if the connected indoor
extension also supports the directional call function, the user can enter the indoor extension
menu “Mode” interface to set the “Mode” option, for example, set the “Mode” to “Slave 1”.
End
11
12
Monitoring Transfer Recording
Setting At home Lock
2021-11-16 12:24
Press the “Transfer” icon.